Where possible, designers are encouraged to locate the transfer device seat no higher than 17 to 19 inches (430 to 485 mm) above the load and unload surface....
Search Results "Fire-Building Surface"
-
1002.6 Transfer Devices for Use with Amusement Rides
-
4. Wheelchair seat depth
The median seat depth across different wheeled mobility devices would provide a reference value for the depth of other common seating surfaces....
-
COSTS TO LOWER MINIMUM TABLE HEIGHT
The need to reach heights above 32 inches interferes with efforts to lower the transfer surface height....
-
Initial Measures and Transfer Setup
This approach is also widely promoted in rehabilitation research (A Clinical Application Guide to Standardized Wheelchair Seating Measurements of the Body and Seating Support Surfaces, See...
-
3. FIXTURES and HARDWARE
If self-closing valves are used, the faucet shall remain open for at least 10 seconds.”xxii Sinks Exposed Pipes and Surfaces: Hot water and drain pipes under lavatories...
-
Standardized Tests of Physical Fitness and Community Ambulation
The subjects rated the level of difficulty from 1 to 10 for both straight travel and turning on the surface using the Level of Difficulty Rating Scale....
-
Multiple Parking Facilities on a Site
., surface lot versus parking garage or deck); dedicated to, and separately serve, different facilities on a site; segmented and separated by guard rails, fencing, or barriers...
-
11B-1002.6 Transfer devices for use with amusement rides
Where possible, designers are encouraged to locate the transfer device seat no higher than 17 to 19 inches (430 to 485 mm) above the load and unload surface....
-
11B-1002.6 Transfer devices for use with amusement rides
Where possible, designers are encouraged to locate the transfer device seat no higher than 17 to 19 inches (430 to 485 mm) above the load and unload surface....
-
1003.2.1 Boat Slips
Where handrail extensions are provided on gangways or transition plates, the handrail extensions shall not be required to be parallel with the ground or floor surface. 7....
-
1003.2.1 Boat Slips
Where handrail extensions are provided on gangways or transition plates, the handrail extensions shall not be required to be parallel with the ground or floor surface. 7....
-
1003.2.1 Boat Slips
Where handrail extensions are provided on gangways or transition plates, the handrail extensions shall not be required to be parallel with the ground or floor surface. 7....
-
11B-1003.2.1 Boat slips
The vertical distance is 10 feet (3050 mm) between the elevation where the gangway departs the landside connection and the elevation of the pier surface at the lowest water level....
-
A. ACCESSIBLE SEATING
Wheelchair Spaces shall be thirty six (36) inches wide (or as otherwise required by Section 802), located on a level floor surface, and shall adjoin accessible routes. ...
-
Accessibility - Flatness and Lippage
Conformance to this standard requires that subfloor surfaces conform to the following: no variation greater than 1/4" in 10 feet, nor 1/16" in 1 ft. from the required plane....
-
201.1 Scope
All areas of newly designed and newly constructed buildings and facilities and altered portions of existing buildings and facilities shall comply with these requirements....
-
Introduction
The regulations provide important information on which buildings and facilities are subject to the standards....
-
TownSteel CSRC Series, Grade 2, Clutched, Conical Rose Cylindrical Locks
Available Finish US26D and US10B stock finish, other finishes upon request Code Compliance: ANSI/BHMA Meets or exceeds all Grade 2 requirements of A156.2-2003 UL Listed 3-hour fire...
-
TownSteel CB Series, Grade 2 Non-Clutched Flat Rose Cylindrical Locks
Quest Available Finish US26D and US10B stock finish, other finishes upon request Code Compliance: ANSI/BHMA Meets or exceeds A156.2-2003 Grade 2 requirements UL Listed 3-hour fire...
-
Technically Infeasible
With respect to an alteration of a building or a facility, something that has little likelihood of being accomplished because existing structural conditions would require removing or altering...
-
SECTION 1008 DOORS, GATES AND TURNSTILES
SECTION 1008 DOORS, GATES AND TURNSTILES [DSA-AC] In addition to the requirements of this section, means of egress, which provide access to, or egress from, buildings or facilities where...
-
Accessible Route
Accessible Route - A continuous unobstructed path connecting all accessible elements and spaces of a building or facility....
-
206.6 Elevators
In a building or facility permitted to use the exceptions to 206.2.3 or permitted by 206.7 to use a platform lift, elevators complying with 408 shall be permitted. 2....
-
F206.6 Elevators
In a building or facility permitted to use the exceptions to F206.2.3 or permitted by F206.7 to use a platform lift, elevators complying with 408 shall be permitted. 2. ...
