Any portion of the building or facility which can be made accessible shall comply to the extent that it is not structurally impracticable....
Search Results "Fire-Building Surface"
Commonly Searched Documents
-
4.1.1(5)(a)
-
Proposed Accessibility Guidelines for Passenger Vessels (link to document)
36 CFR 1196 Passenger Vessels Accessibility Guidelines (NPRM) Preamble Chapter V1: Application and Administration Chapter V2: Scoping Requirements Chapter V3: Building Blocks...
-
APPENDIX
appendix contains materials of an advisory nature and provides additional information that should help the reader to understand the minimum requirements of the guidelines or to design buildings...
-
Dining Areas [5.4]/ Raised Platforms [5.7]
(An exception is allowed for mezzanines that accommodate no more than a third of the seating area in buildings without elevators)....
-
Valet Parking
Also, valet service may not be available during all hours of building operation or may be discontinued....
-
List of Subjects for 28 CFR Part 35
Administrative practice and procedure, Buildings and facilities, Civil rights, Communications, Individuals with disabilities, Reporting and recordkeeping requirements, State and local governments...
-
11B-606.6 Adjacent side wall or partition
However, some Local Building Officials or other Authorities Having Jurisdiction may apply it to both....
-
CIRCULATION PATH
A CIRCULATION PATH is a pedestrian route provided within a building, facility or site and may or may not (in the case of stairs) include an accessible route of travel....
-
11B-403.5.1 Clear width
Except as provided in Sections 11B-403.5.2 and 11B-403.5.3, the clear width of walking surfaces shall be 36 inches (914 mm) minimum. Exceptions: 1. ...
-
"Wheelchair" (Section-by-Section Analysis)
"Typical indoor and outdoor pedestrian areas" refer to locations and surfaces used by and intended for pedestrians, including sidewalks, paved paths, floors of buildings, elevators, and...
-
"Wheelchair" (Section-by-Section Analysis)
"Typical indoor and outdoor pedestrian areas" refer to locations and surfaces used by and intended for pedestrians, including sidewalks, paved paths, floors of buildings, elevators, and...
-
11B-705.1.2.3 Islands or cut-through medians
cut-through less 2 inches (51 mm) maximum on each side, placed at the edges of the pedestrian island or cut-through median, and shall be separated by 24 inches (610 mm) minimum of walking surface...
-
404 Doors, Doorways, and Gates
series (404.2.6) clarify the height of door and gate hardware and add an exception for gates at pools, spas, and hot tubs (404.2.7) revise an exception for door and gate surface...
-
11B-406.5.12 Detectable warnings
width of the curb ramp (exclusive of flared sides) and shall extend either the full depth of the curb ramp or 24 inches (610 mm) deep minimum measured from the back of the curb on the ramp surface...
-
M303.2.6 Edge Protection (Section-by-Section Analysis)
Protection), the final rule requires platforms with wheelchair spaces that are raised more than 1½ inches in height to provide a minimum 2-inch-high edge protection, measured from the surface...
-
Maximum Slope at Ground Level
A berm may be a natural sloped surface that is present in a hilly play area site, or a ground-level route built with slopes....
-
606.3 Height
Lavatories and sinks shall be installed with the front of the higher of the rim or counter surface 34 inches (865 mm) maximum above the finish floor or ground. EXCEPTIONS: 1....
-
Amusement Ride Seats Designed for Transfer
When greater distances are required for transfer, consideration should be given to providing gripping surfaces, seat paddings, and avoiding sharp or protruding objects....
-
1007.3.2 Golf Club Reach Range Area
This includes accessible routes provided adjacent to or, where provided, on the playing surface of the hole....
-
Tent Pads and Tent Platforms [1013]
Tent pads and tent platforms are defined spaces with prepared surfaces for setting up and securing tents....
-
Curb Ramps and Blended Transitions (R309.4) (Section-by-Section Analysis)
Detectable warning surfaces are not required on curb ramps and blended transitions that connect the access aisle to the sidewalk, including where the sidewalk is at the same level as the...
-
F. Check-In Areas
If a permanent reception counter is used for check in, make sure to provide a writing surface at an accessible height for people who use a wheelchair, scooter, or other mobility device....
-
4.6.1 General
In alterations, where a condition for exception in section 1.1 prohibits full compliance with a specific requirement for clear floor or ground space surface, slope, size, or location, the...
-
2. Referenced Documents
Guide for Conducting Subjective Pavement Ride Quality Ratings E2133 Standard Test Method for Using a Rolling Inclinometer to Measure Longitudinal and Transverse Profiles of a Traveled Surface...