Tent pads and tent platforms are defined spaces with prepared surfaces for setting up and securing tents....
Search Results "Fire-Building Surface"
Filters
Commonly Searched Documents
-
1013.1 General
-
§ 38.159(b)(7) Platform gaps
Any openings between the platform surface and the raised barriers shall not exceed 5/8 inch (16 mm) in width....
-
11B-406.5.12 Detectable warnings
width of the curb ramp (exclusive of flared sides) and shall extend either the full depth of the curb ramp or 24 inches (610 mm) deep minimum measured from the back of the curb on the ramp surface...
-
11B-1007.3.2 Golf club reach range area
This includes accessible routes provided adjacent to or, where provided, on the playing surface of the hole. ...
-
11B-1007.3.2 Golf club reach range area
This includes accessible routes provided adjacent to or, where provided, on the playing surface of the hole. ◼ ...
-
11B-308.3.1 Unobstructed
Operable parts of fuel dispensers shall be permitted to be 54 inches (1372 mm) maximum measured from the surface of the vehicular way where fuel dispensers are installed on existing curbs...
-
11B-705.1.2.3 Islands or cut-through medians
cut-through less 2 inches (51 mm) maximum on each side, placed at the edges of the pedestrian island or cut-through median, and shall be separated by 24 inches (610 mm) minimum of walking surface...
-
11B-406.5.12 Detectable warnings
width of the curb ramp (exclusive of flared sides) and shall extend either the full depth of the curb ramp or 24 inches (610 mm) deep minimum measured from the back of the curb on the ramp surface...
-
A. Access Board
. 792).1 The Access Board is responsible for developing accessibility guidelines and standards under various laws to ensure that individuals with disabilities have access to and use of buildings...
-
11B-216.8 Toilet rooms and bathing rooms
Existing buildings that have been remodeled to provide specific toilet rooms or bathing rooms for public use that comply with these building standards shall have the location of and the...
-
11B-216.8 Toilet rooms and bathing rooms
Existing buildings that have been remodeled to provide specific toilet rooms or bathing rooms for public use that comply with these building standards shall have the location of and the...
-
test response
NodeKey=373628 This product has worked really well in our medical office buildings. ...
-
Bed Height Fact Sheet
All beds (including the railings, box spring, and mattress) within a mobility accessible (ADA) room should be no higher than 23” and no lower than 17” above the floor surface....
-
III-6.1000 General
The new floor must comply with, for example, ADAAG requirements for a nonslip surface or with the ADAAG carpeting requirements, if applicable....
-
Bradley 20.6 Gallon Waste Receptacle 355
Model 355 Surface Mounted 20.6 Gallon Capacity Surface Mounted...
-
International Code Council (ICC): Become an ICC Certified Accessibility Inspector/Plans Examiner
Demands for Accessible Buildings Are Growing: Become an ICC Certified Accessibility Inspector/Plans Examiner now The 2010 U.S....
-
Employee Parking Lot
Is there a difference between parking spaces marked or reserved for employees and parking spaces that are just in the back of the building, unmarked but intended for employees?...
-
Advent Sebring Wall Sconce with Emergency Battery Back-Up
. • Emergency battery provides a minimum of 90 minutes illumination, meeting National Fire Protection Association Life Safety Code requirements. Consult factory for lumen output....
-
Rockwood Manufacturing Company 596S Hospital Push Pull Latch 2-3/4" Backset
• UL listed for all fire doors. • Compact 2-11/16" x 4-3/8" covers. • Paddle projection 3". • Five mounting postions. • U.S. Patent No. 6,398,274 B1....
-
Rockwood Manufacturing Company 596 Hospital Push Pull Latch 5" Backset
• UL listed for all fire doors. • Compact 2-11/16" x 4-3/8" covers. • Paddle projection 3". • Five mounting positions. • U.S. Patent No. 6,398,274 B1....
-
Function Keys
It included specifications for key surfaces to be raised 1/25 inch minimum and that outer edges have a radius of 1/50 inch maximum (707.4.2)....
-
Step 2: Identify the Presence of Limiting Factors
What sort of surface is firm and stable? If the answer to both of the following questions is yes, the surface is probably firm and stable....
-
Madden Manufacturing Round Handrail (ADA Compliant)
Available in kit form or full length extrusions, each system is carefully designed and packaged to arrive at your build site within 5 days of order placement....
-
Hager Companies 5200 Series - Heavy Duty Door Closer
The commercial applications ideal for these closers include schools, medical facilities, institutions, and hospitals as well as office buildings and any entrance door with high foot traffic...
