The faucet is field researched and specifically engineered to meet the demands of the commercial plumbing industry....
Search Results "ANSI/IEEE: American National Standards Institute/ Institute of Electrical and Electronics Engineers"
Filters
Commonly Searched Documents
-
Sloan AD-84 Four Station AER-DEC Integrated Sink with Faucet, Soap Dispenser and Hand Dryer
-
Academy of Doctors of Audiology
Mission The Academy of Doctors of Audiology is dedicated to the advancement of practitioner excellence, high ethical standards, professional autonomy and sound business practices in the...
-
Section 5.0 Dissemination Activities
The intermediate-term goal is to provide knowledge to improve existing standards....
-
11B-202.3 Alterations
Residential dwelling units not required to be accessible in compliance with a standard issued pursuant to the Americans with Disabilities Act or Section 504 of the Rehabilitation Act of...
-
After January 26, 1992
Any state or local government facility that was altered after January 26,1992 was required to be altered in compliance with the ADA Standards or UFAS....
-
Hafele America Co. Pocket Door Hardware
Pocket Door Hardware Benefits - Designed to fit into standard 2x4 wood or steel constructed interior walls - Provides an efficient way to save space in tight room designs - Specially...
-
M101.5 Dimensions
The MDE Standards are based on adult dimensions and anthropometrics. Dimensions that are not stated as “maximum” or “minimum” are absolute....
-
407.4.6.3 Keypads
Car control keypads shall be in a standard telephone keypad arrangement and shall comply with 407.4.7.2....
-
i.
"Suspicious Minds" Exhibit ramp leading to the exhibits; and See Standards § 4.8.5(3)....
-
407.4.6.3 Keypads
Car control keypads shall be in a standard telephone keypad arrangement and shall comply with 407.4.7.2....
-
E202.1 General
ICT shall be exempt from compliance with the Revised 508 Standards to the extent specified by E202....
-
E202.4 Federal Contracts
ICT acquired by a contractor incidental to a contract shall not be required to conform to the Revised 508 Standards....
-
E201.1 Scope
ICT that is procured, developed, maintained, or used by agencies shall conform to the Revised 508 Standards....
-
225(d)(1)(B)
(B) establish minimum standards that shall be met in carrying out subsection (c) of this section;...
-
Station platforms
(DOT ADA Standard 810.5.3.)...
-
M18
[ADA Standards § 4.16.5] Yes No...
-
11B-705.1.1.3.1
Detectable warning surfaces shall be yellow and approximate FS 33538 of Federal Standard 595C....
-
§40.3(b)(3)
(3) The alteration of an existing building, or of such portions thereof, to which application of the standards is not structurally feasible....
-
ADMINISTRATIVE AUTHORITY
A governmental agency that adopts or enforces regulations and standards for the design, construction, or alteration of buildings and facilities....
-
§100.201a(b)
(b) The addresses of organizations from which the referenced standards can be obtained appear below:...
-
b. Telephone Communications
Telephone relay services involve a relay operator who uses both a standard telephone and a TTY to type the voice messages to the TTY user and read the TTY messages to the standard telephone...
-
232 Detention Facilities and Correctional Facilities
232 Detention Facilities and Correctional Facilities Section 232 of the 2010 Standards establishes requirements for the design and construction of cells, medical care facilities, and...
-
E.4. - What are examples of issues an agency may wish to consider when drafting a solicitation to acquire EIT?
To be considered eligible for award, offerors must propose goods and/or services that meet the applicable provisions of the Access Board’s standards as identified by the agency....
-
A4.17.3 Size and Arrangement
This section requires use of the 60 in (1525 mm) standard stall (Figure 30(a)) and permits the 36 in (915 mm) or 48 in (1220 mm) wide alternate stall (Figure 30(b)) only in alterations where...
