Section 505.3 covers the current ADA Standards for the continuity of handrails.
Search Results "Clear Floor Area"
-
Continuity: ADA Standard Section 505.3
-
11B-804.2.2 U-Shaped
In U-shaped kitchens enclosed on three contiguous sides, clearance between all opposing base cabinets, counter tops, appliances, or walls within kitchen work areas shall be 60 inches (1524...
-
11B-804.2.2 U-Shaped
In U-shaped kitchens enclosed on three contiguous sides, clearance between all opposing base cabinets, counter tops, appliances, or walls within kitchen work areas shall be 60 inches (1524...
-
Waviness Index
Waviness Index The Waviness Index, ASTM E 1486, Standard Test Method for Determining Floor Tolerances Using Waviness, Wheel Path and Levelness Criteria, was developed in response to the...
-
11B-604.8.1.4 Toe clearance
At least one side partition shall provide a toe clearance of 9 inches (229 mm) minimum above the finish floor and 6 inches (152 mm) deep minimum beyond the compartment-side face of the partition...
-
11B-604.8.1.4 Toe clearance
At least one side partition shall provide a toe clearance of 9 inches (229 mm) minimum above the finish floor and 6 inches (152 mm) deep minimum beyond the compartment-side face of the partition...
-
Section 35.151(f) Housing at a place of education (Section-by-Section Analysis)
There are other differences between the two sets of standards as well with respect to requirements for accessible windows, alterations, kitchens, accessible route throughout a unit, and clear...
- Pressalit Care PLUS Support Arm Height and Sideways Adjustable Swing Grab Bar
- Pressalit Care PLUS Support Arm Height Adjustable Swing Grab Bar
-
Usable Door
One commenter stated that a clear definition of "usable door" is required. Response....
-
Substantially Limited in Working
These include: the type of job from which the individual has been disqualified because of the impairment; the geographical area in which the person may reasonably expect...
-
Same Management or Building
The 2010 Standards add a new exception that allows multiple assembly areas that are in the same building and under the same management, such as theaters in a multiplex cinema and lecture...
-
Integration
(Bleachers with notches or cut-out areas will provide both integration and companion seating.)...
-
D. Reasonable Modifications
where food is served and most areas where medical care is provided....
-
Temporary Solutions for Election Day - Hallways and Corridors - Voters Who are Blind or Who Have Low Vision
The bottom of the skirting or detectable object must be no higher than 27 inches above the floor....
-
4.1.3(17)(a)
are provided, then they shall comply with 4.31.2 through 4.31.8 to the extent required by the following table: Number of each type of telephone provided on each floor...
-
Construction and Maintenance Practices
Stagger speed humps to block only one lane at a time or limit them to the center of the road, leaving 32 inches (815 millimeters) of clear passage at each side....
-
III-7.8200 Restaurants and cafeterias
In restaurants, generally all dining areas and five percent of fixed tables (but not less than one) must be accessible....
-
WALK
[DSA-AC] An exterior prepared surface for pedestrian use, including pedestrian areas such as plazas and courts. (As differentiated from the definition of “Sidewalk”.)...
-
WALK
[DSA-AC] An exterior prepared surface for pedestrian use, including pedestrian areas such as plazas and courts. (As differentiated from the definition of “Sidewalk”.)...
-
4.7.10 Diagonal Curb Ramps
The bottom of diagonal curb ramps shall have 48 in (1220 mm) minimum clear space as shown in Fig. 15(c) and (d)....
-
Diagonal Curb Ramps [§406.6]
Diagonal Curb Ramps [§406.6] If curb ramps are placed diagonally at an intersection, it is important that clear space 48” long min. is available at the bottom that is outside active...
-
11B-603.4 Coat hooks, shelves and medicine cabinets
Shelves shall be located 40 inches (1016 mm) minimum and 48 inches (1219 mm) maximum above the finish floor....
-
Destination-Oriented Elevators
Destination-oriented elevators are different from typical elevators in that they provide a means of indicating the desired floor at the location of the call button, usually through a key...