Measurements are stated in metric and U.S. customary units, and each system of measurement is to be used independently of the other....
Search Results "Tape Measure"
-
R103 Conventions (Section-by-Section Analysis)
-
Verify Electrical
Measure to top or bottom of boxes 11B-308.1.1 Heights of all electrical switch boxes....
-
703.3.1 Dimensions and Capitalization
Table 703.3.1 Braille Dimensions MEASUREMENT RANGE MINIMUM IN INCHES MAXIMUM IN INCHES Dot base diameter 0.059...
-
1.2.6
1.2.6 When local variations (flatness) in running slope of ramps are measured according to 1.1.13 at least 80% (rounded to the nearest whole number) of the measurements should not exceed...
-
604.8.1.1 Size
Wheelchair accessible compartments shall be 60 inches (1525 mm) wide minimum measured perpendicular to the side wall, and 56 inches (1420 mm) deep minimum for wall hung water closets and...
-
604.8.1.1 Size
Wheelchair accessible compartments shall be 60 inches (1525 mm) wide minimum measured perpendicular to the side wall, and 56 inches (1420 mm) deep minimum for wall hung water closets and...
-
604.8.1.1 Size
Wheelchair accessible compartments shall be 60 inches (1525 mm) wide minimum measured perpendicular to the side wall, and 56 inches (1420 mm) deep minimum for wall hung water closets and...
-
11B-604.8.1.1 Size
Wheelchair accessible compartments shall be 60 inches (1524 mm) wide minimum measured perpendicular to the side wall, and 56 inches (1422 mm) deep minimum for wall hung water closets and...
-
D. Election Day Compliance Review
In the materials provided to each Election Judge for Election Day, the County will include a checklist of the temporary measures to be implemented on Election Day at each...
-
D. Election Day Compliance Review
In the materials provided to each Judge of Election for Election Day, the County will include a checklist of the temporary measures to be implemented on Election Day at each polling...
-
2.2.5 Grip Strength
2.2.5 Grip Strength Four types of grip strength measurements for the dominant hand were assessed....
-
What surface characteristics are required of an accessible route?
No standards or methods of measurement are specified in scoping or technical provisions, although the Appendix to ADAAG contains advisory recommendations for slip resistance values derived...
-
Transfer Surface Height (M301.2.1 and M302.2.1)
M301.2.1 and M302.2.1 would require the height of the transfer surface during patient transfer to be 17 inches minimum and 19 inches maximum measured from the floor to the top of the transfer...
-
Introduction
Data collection included 3 dimensional measurements of approximately 90 points located on the body and device....
-
11B-809.10.7.1 Floor space
The floor space at water closets shall be 48 inches (1219 mm) wide minimum measured perpendicular to the side wall....
-
11B-221.2.1.5 Stadium-style movie theaters
following criteria: Located within the rear 60 percent of the seats provided in the theater; or Located within the area of the theater in which the vertical viewing angles (as measured...
-
11B-809.10.7.1 Floor space
The floor space at water closets shall be 48 inches (1219 mm) wide minimum measured perpendicular to the side wall....
-
11B-221.2.1.5 Stadium-style movie theaters
following criteria: Located within the rear 60 percent of the seats provided in the theater; or Located within the area of the theater in which the vertical viewing angles (as measured...
-
11B-809.10.6.3 Clearance
A clearance of 36 inches (914 mm) wide minimum by 48 inches (1219 mm) long minimum measured from the control wall shall be provided outside the shower as illustrated in Figure 11B-809.10.6.3...
-
Don-Jo Mfg., Inc. Commercial Kick Plates 90
, 606, 609, 612, 613, 619, 626, 628, 629, 630, 670, BT, DB, EN Fastenerss #6 x 5/8" SMS Options MAG - magnetic backing for metal doors, SM - double face tape...
-
Wooster Products NITEGLOW® Anti-Slip Glow-In-The-Dark Safety Products
Our pigment is embedded in a hard epoxy mixture, it is not just a thin adhesive tape....
-
1630.11 Administration of tests
that impairs sensory, manual or speaking skills, the test results accurately reflect the skills, aptitude, or whatever other factor of the applicant or employee that the test purports to measure...
-
M302.4.1 Clearance in Base
The base of the diagnostic equipment shall provide a clearance 39 inches (990 mm) wide minimum, 6 inches (150 mm) high minimum measured from the floor, and 36 inches (915 mm) deep minimum...
-
M301.4.1 Clearance in Base
The base of diagnostic equipment shall provide a clearance 39 inches (990 mm) wide minimum, 6 inches (150 mm) high minimum measured from the floor, and 36 inches (915 mm) deep minimum measured...
