Search Results "Height Adjustable"

• State and Local Documents > Codes and Standards > 2022 California Standards
  11B-609.4 Position of grab bars

  The height of the lower grab bar on the back wall of a bathtub shall comply with Section 11B-607.4.1.1 or 11B-607.4.2.1....

• Federal Documents > Standards > 36 CFR Part 1195 Standards for Accessible Medical Diagnostic Equipment
  M305.2.5 Surface Hazards

  Transfer supports and surfaces adjacent to transfer supports shall be free of sharp or abrasive components and shall have eased edges.

• Federal Documents > Standards > 36 CFR Part 1195 Standards for Accessible Medical Diagnostic Equipment
  M305.2 Transfer Supports

  Transfer supports shall comply with M305.2.

• Federal Documents > Preamble to Standards > 36 CFR Part 1195 Standards for Accessible Medical Diagnostic Equipment - Preamble
  M305.2 Transfer Supports (Section-by-Section Analysis)

  This is an introductory section. As discussed above in Section IV.E.1. (Significant Changes – Transfer Supports), the Access Board strengthened the transfer support requirements and...

• Federal Documents > Preamble to Standards > 36 CFR Part 1195 Standards for Accessible Medical Diagnostic Equipment - Preamble
  M305.2.5 Surface Hazards (Section-by-Section Analysis)

  The proposed rule did not provide any specific restrictions regarding surface hazards around the transfer supports. No public comments were submitted on this issue, but the MDE...

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.4.6 Transfer Support Gripping Surface Cross Section and Clearances for M301, M302, and M305.2

  5.4.6 Transfer Support Gripping Surface Cross Section and Clearances for M301, M302, and M305.2 Description: This provision prescribes a cross-sectional profile of the transfer...

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.4.4 Transfer Support Distance from Transfer Surface Recommendations for M301 and M302

  5.4.4 Transfer Support Distance from Transfer Surface Recommendations for M301 and M302 Description: This minimum distance ensures that the transfer support is within reach of the...

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.4 Transfer Supports

  5.4 Transfer Supports.

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.4 Transfer Supports Recommendations

  5.4 Transfer Supports Recommendations

• Rulemaking Process Documents > NPRMS > 36 CFR Part 1195 Proposed Accessibility Standards for Medical Diagnostic Equipment NPRM
  M305.2 Transfer Supports

  Transfer supports shall comply with M305.2.

• Federal Documents > Technical Assistance > Access to Medical Care for Individuals with Mobility Disabilities
  Features of Accessible Exam Tables

  Removable/adjustable support rails with continuous gripping surfaces 2. 30” X 48” minimum clear floor space adjacent to exam table and adjoining accessible route 3....

• State and Local Documents > Codes and Standards > 2012 Texas Accessibility Standards
  703.4.1 Height Above Finish Floor or Ground

  Tactile characters on signs shall be located 48 inches (1220 mm) minimum above the finish floor or ground surface, measured from the baseline of the lowest tactile character and 60...

• Federal Documents > Standards > ABA Accessibility Standard for GSA Facilities Pocket Guide
  703.4 Installation Height and Location

  Signs with tactile characters shall comply with 703.4.

• State and Local Documents > Codes and Standards > 2012 Texas Accessibility Standards
  703.4 Installation Height and Location

  Signs with tactile characters shall comply with 703.4.

• Federal Documents > Technical Assistance > ADA Guide for Small Businesses
  Fixed Seating and Tables

  An accessible table has a surface height of no more than 34 inches and no less than 28 inches above the floor....

• Federal Documents > Standards > 2010 ADA Standards
  Shower Compartment Seats: ADA Standard Section 610.3

  Section 610.3 covers the current ADA Standards for shower compartment seats.

• State and Local Documents > Codes and Standards > 2022 California Standards
  11B-809.10.8.1 Location

  Lavatories without base cabinets shall be installed with the centerline 18 inches (457 mm) minimum from an adjoining wall or fixture to allow for forward approach. Lavatories with...

• State and Local Documents > Codes and Standards > 2022 California Standards
  11B-703.5.6 Height from finish floor or ground

  Visual characters shall be 40 inches (1016 mm) minimum above the finish floor or ground. Exceptions: Visual characters indicating elevator car controls shall not be required...

• Federal Documents > Standards > 36 CFR Part 1195 Standards for Accessible Medical Diagnostic Equipment
  M305.2.2.1 End Transfer Supports

  Transfer supports for transfer surfaces complying with M301.2.3.1 and M305.2.2.1 shall be 15 inches (380 mm) long minimum. Transfer supports shall be positioned along 13 ½ inches...

• Federal Documents > Standards > 36 CFR Part 1195 Standards for Accessible Medical Diagnostic Equipment
  M305.2.4.1 Circular Cross Section

  Transfer supports with circular cross sections shall have an outside diameter of 1 ¼ inches (32 mm) minimum and 2 inches (51 mm) maximum.

• Federal Documents > Standards > 36 CFR Part 1195 Standards for Accessible Medical Diagnostic Equipment
  M305.2.1.2 Side Transfer Supports

  Transfer supports for transfer surfaces complying with M301.2.3.2 shall be capable of supporting transfer on each side of the transfer surface.

• Federal Documents > Standards > 36 CFR Part 1195 Standards for Accessible Medical Diagnostic Equipment
  M305.2.1.1 End Transfer Supports

  Transfer supports for transfer surfaces complying with M301.2.3.1 and M302.2 shall be located on the short side (length) opposite the transfer side.

• Federal Documents > Standards > 36 CFR Part 1195 Standards for Accessible Medical Diagnostic Equipment
  M305.2.2.2 Side Transfer Supports

  Transfer supports for transfer surfaces complying with M301.2.3.2 shall be 28 inches (710 mm) long minimum and shall be positioned along the width of transfer...

• Federal Documents > Technical Assistance > Access to Medical Care for Individuals with Mobility Disabilities
  Typical Transfer Techniques: Staff Assistance and Patient Lifts

  Typical Transfer Techniques: Staff Assistance and Patient Lifts Some individuals will need additional assistance to get on and off an exam table, even if it lowers to 17‒19 inches...