communication-related elements of ATMs to be auxiliary aids and services, rather than structural elements, to which the Safe Harbor allowance for elements built in compliance with the 1991 Standards...
Search Results "Standards Development"
-
11B-707.4 Privacy
-
11B-206.2.3 Multi-story buildings and facilities
[2010 ADA Standards] 1....
- Willoughby Industries ASHS-1013-06-15-HC Ligature-Resistant 15" wide Lavatory
- Delta Single Handle Pull-Out Kitchen Faucet 472-DST
- BEST Door Lever Hardware Cylindrical Locks - 5K
- Trimco 1069 Series ADA Pocket Door Pull
- Willoughby Industries DF-1015-96-HC Rear Mounted Drinking Fountain
- Inpro Corporation IPC® Designer Kickplates
- SafePath EZCurb™ Wheelchair Ramps - Vertical Barrier Removal
- Willoughby Industries UW-1412-WO Series Straddle Urinal Washout Type
-
Section 1193.39 Prohibited reduction of accessibility, usability and compatibility [1193.29 in the NPRM] (Section-by-Section Analysis)
Providing that no change shall be undertaken which decreases or has the effect of decreasing accessibility is a common principle in disability access codes and standards and was borrowed...
-
§1607.7 Use of other validity studies.
While publishers of selection procedures have a professional obligation to provide evidence of validity which meets generally accepted professional standards (see section 5C above), users...
-
6. Regulatory Analyses
We request comments on the following to assess the impacts of the SNPRM: • The extent to which the AASHTO Guide, or other design guides and standards are used for shared use paths....
-
3.3.1 Research Data
Access Board staff to find as many studies as possible that were relevant to various accessibility standards....
-
Maximum side reach ranges. (Section-by-Section Analysis)
The 2004 ADAAG includes a change in the maximum height of a side reach range from 54 inches in the current ADA Standards, to 48 inches in the 2004 ADAAG. ...
-
Effective date: Triggering event. (Section-by-Section Analysis)
The information provided by commenters indicates that the first-use approach would not provide adequate guidance on when the proposed standards would apply to certain facilities and elements...
-
Operable Parts
They also suggested incorporating the provisions of section 309 of the 2010 ADA standards word for word rather than by reference, as well as new requirements to allow at least one mode of...
-
Comments
transportation commenters suggested that a longer-term solution to the problem would be to work with wheelchair manufacturers and the Department of Health and Human Services to establish standards...
-
206.2.3 Multi-Story Buildings and Facilities
Florida requirements may be waived down to the ADA Standards requirements....
-
§35.161 Telecommunication Devices for the Deaf (TDD's) (Section-by-Section Analysis)
The relay services required by title IV would involve a relay operator using both a standard telephone and a TDD to type the voice messages to the TDD user and read the TDD messages to the...
-
409.1 General (Section-by-Section Analysis)
This proposed requirement in 409.1 would be new to the 508 Standards....
-
D. Second Advance Notice of Proposed Rulemaking (2011 ANPRM)
More importantly, we needed to obtain further public comment on major issues and harmonize with the European Commission’s ICT standardization efforts that were already underway at that time...
-
A. Question 1: Applicability of Section 904.4.1’s Exception
service counter be “36 inches (915 mm) high maximum above the finish floor,” and Section 904.4.1 further requires that a sales or service counter be “36 inches (915 mm) long minimum.” 2010 Standards...
-
III-4.4600 Seating in assembly areas
The ADA accessibility standard for alterations requires wheelchair seating to be dispersed (i.e. , provided in more than one location) only in assembly areas with fixed seating for more...