Section 7.4 of FSTAG explains the accessibility requirements for trails, including trail surfacing, clear tread width, grade and cross slope, resting intervals, passing spaces, tread obstacles...
Search Results "Side Transfer Surface"
Filters
Commonly Searched Documents
-
Technical Requirements for Accessible Hiker/Pedestrian Trails
-
Transit Stops (R308.1) (Section-by-Section Analysis)
The surfaces of boarding and alighting areas and boarding platforms must comply with the technical requirements for surfaces (see R302.7)....
-
Innerface Trio Interior Signage
The curved top and dimensional side accents are offered in a variety of laminate, texture and solid color finishes. ...
-
Accessible Parking
This route must have no steps or steeply sloped surfaces and it must have a firm, stable, slip-resistant surface....
-
Tread Obstacles on Beach Access Routes
When the surface of the beach access route is paved or is built with boards, tread obstacles must not be more than a half of an inch (13 millimeters) high....
-
1018.5 Obstacles
Where the surface is other than concrete, asphalt, or boards, obstacles are permitted to not exceed 1 inch in height measured vertically to the highest point....
-
R308.1 Transit Stops
Transit stops should be located so that there is a level and stable surface for boarding vehicles....
-
Instrumentation for Analysis
Appendix C) was created to collect data on the 11 trail segments including Rotational Penetrometer readings, inspection location in feet from trailhead, ruts, tread obstacles, or other surface...
-
11B-812.7.2 Marking
The color of the borderlines, hatched lines, and letters shall contrast with that of the surface of the access aisle....
-
1018.2 Aisles in assembly spaces
for applications listed in Section 1.9.1 regulated by the Division of the State Architect-Access Compliance, shall also comply with Chapter 11A or Chapter 11B, Section 11B-403 _|Walking Surfaces...
-
11B-505.10 Handrail extensions
Handrail gripping surfaces shall extend beyond and in the same direction of stair flights and ramp runs in accordance with Section 11B-505.10....
-
11B-235.2 Boat slips
For example, a single pier 25 feet (7620 mm) long and 5 feet (1525 mm) wide (the minimum width specified by Section 11B-1003.3) allows boats to moor on three sides....
-
Hoyer Manual Hydraulic Lift
Description:Â Hoyer's Manual Hydraulic Lift features an ergonomically placed pump handle for ease of use, and the handle rotates to allow operation from either side of lifter....
-
ASME
that at least two flat steps be provided at the entrance and exit of every escalator and that steps on escalators be demarcated by yellow lines 2 inches wide maximum along the back and sides...
-
F240.1.1 Additions
At the time the second phase is complete, ramps must be used to connect at least 5 of the elevated play components and transfer systems are permitted to be used to connect the rest of the...
-
Fraudulent purchase of designated accessible seating. (Section-by-Section Analysis)
However, the proposed rule preserves the right of an individual with a disability to transfer his or her ticket for individual events and clarifies that the intermittent use of the wheelchair...
-
DOT Response
provider, the applicant, and the person responsible for the applicant's well-being should discuss the parameters of paratransit service, the paratransit agency's policies regarding attended transfers...
-
240.1.1 Additions
At the time the second phase is complete, ramps must be used to connect at least 5 of the elevated play components and transfer systems are permitted to be used to connect the rest of the...
-
Model Building Codes and Industry Standards
For example, unlike the ADA guidelines, the ANSI standards require an additional vertical grab bar at water closets, transfer shower stalls, and tubs....
-
2) Residential facilities/transient lodging
In addition, where there are more than 50 rooms, approximately one percent of rooms must be accessible rooms with a special roll-in/transfer shower....
-
11B-240.2.2 Elevated play components
For purposes of this section, ramps, transfer systems, steps, decks, and roofs are not considered elevated play components....
-
Rebuilding Together Twin Cities - Minneapolis, MN
General Repair Program creates healthier, more livable homes by providing volunteer-delivered repairs including weatherizing, cleaning, installing flooring, patching and painting, siding...
-
Norton 6000 Series Low Energy Operator
Available for push or pull side mounting, the 6000 Series can be operated manually or activated via wall switches or radio frequency devices....
-
Issue 3: Which signal? Speech WALK messages necessary
In Figure 6, it appears that the required APS separation (10 feet minimum) could have been achieved here by locating stub poles to the left side of the left ramp and the right side of the...
