The height of amusement ride seats designed for transfer shall be 14 inches (355 mm) minimum and 24 inches (610 mm) maximum measured from the surface of the load and unload area....
Search Results "NTTAA: National Technology Transfer and Advancement Act of 1995"
-
1002.5.2 Transfer Height
-
6. Transfer Surface Height
Transfer Surface Height 6.3 Diagnostic Imaging Equipment Refer to the Rationale found in Section 5.3 for M301.2.1 and to Section 4.3....
- Berlin Design Research Lab Mobile Lorm Glove Prototype
-
Thresholds: ADA Standard Section 608.7
Section 608.7 covers the current ADA Standards for thresholds in shower compartments.
-
Conclusions
While there appears to be a growing body of literature on transfers there is scarce evidence related to the impact of setup on the performance of independent transfers....
-
G.6.i. - What is the undue burden exception?
Agencies have additional responsibilities under Sections 501 and 504 of the Rehabilitation Act....
-
§ 1194.2(c)
(c) Except as provided by §1194.3(b), this part applies to electronic and information technology developed, procured, maintained, or used by agencies directly or used by a contractor under...
-
Transfer Height
Transfer Height The height of the transfer device must be between 14 and 24 inches above the load and unload area surface....
-
Transfer Devices for Use with an Amusement Ride
Transfer Devices for Use with an Amusement Ride Transfer devices may also be used to provide access onto an amusement ride....
-
M301.2.1, M302.2.1 Transfer Height
M301.2.1, M302.2.1 Transfer Height Proposed requirement: The height of the transfer surface during patient transfer shall be 17 inches (430 mm) minimum and 19 inches (485 mm) maximum...
-
Air Carrier Access Act
Air Carrier Access Act, for questions pertaining to air transportation, call Department of Transportation: Aviation Consumer Protection Division 800-778-4838 (voice) 800-455-9880...
-
§ 1194.2(b)
(b) When procuring a product, each agency shall procure products which comply with the provisions in this part when such products are available in the commercial marketplace or when...
-
508 Chapter 2: Scoping Requirements
[See subsections ...]
-
E203 Access to Functionality
[See subsections ...]
-
407.2 Contrast
Where provided, keys and controls shall contrast visually from background surfaces. Characters and symbols shall contrast visually from background surfaces with either light...
-
403 Biometrics
[See subsections ...]
-
401 General
[See subsections ...]
-
501 General
[See subsections ...]
-
Chapter 4: Hardware
[See subsections ...]
-
Chapter 5: Software
[See subsections ...]
-
H.4.i. - Does presentation equipment procured have to meet the Access Board standards?
Yes. Presentation equipment, such as LCD data projectors and laptop computers, are considered EIT and therefore covered by the Access Board's standards, unless an exception applies....
-
B.3.ii. - Is there a preference for a product that strictly meets the technical provisions of Subpart B over a product that provides the same or greater accessibility through equivalent facilitation?
No. Purchase of either EIT product would satisfy an agency’s obligations under Section 508. Award should be made to the source whose offer represents the best value to the Government...
-
B.1.i. - Is EIT limited to products?
No. EIT, like IT, also includes services. For example, some agencies seek to satisfy their desktop computing needs through so-called "seat management" service contracts. Under a seat...
-
D.1. - How does Section 508 affect the requirements development phase of an acquisition?
Section 508 requires agencies to take additional considerations into account when defining their needs for EIT – namely the Access Board’s standards. As noted above, Section 508...