3.3.6 Knee Clearance Height, minimum Knee clearance heights for the four sets of standards range from 650 mm (25.6 in.) (Australia) to 700 mm (27.6 in.) (U.K.) (Figure 3‒6). The...
Search Results "Boarding Device"
Commonly Searched Documents
-
3.3.6 Knee Clearance Height, minimum
-
3.3.5 Seat Height
3.3.5 Seat Height Height dimension standards for seats prescribed in the Australian, Canadian and U.S. standards were very similar (480 mm or 18.9 in., 480 mm or 18.9 in. and 485...
-
3.3.8 Knee Clearance Depth, minimum
3.3.8 Knee Clearance Depth, minimum Knee clearance depths for the four sets of standards range from 200 mm (8 in.) in Canada to 280 mm (11 in.) in the U.S. (Figure 3‒8). None of...
-
3.3.7 Toe Clearance Height, minimum
3.3.7 Toe Clearance Height, minimum There is relatively large disparity between the standards for toe clearance height, with the U.S. having the lowest (230 mm or 9 in.),...
-
3.3.9 Toe Clearance Depth, minimum
3.3.9 Toe Clearance Depth, minimum Toe clearance depths for the standards range from 150 mm (6 in.) in the U.S. to 230 mm (9 in.) in Canada (Figure 3‒9). None of the comparison...
-
§ 38.23 Mobility aid accessibility
[See subsections ...]
-
407.3.3.1 Height
The device shall be activated by sensing an obstruction passing through the opening at 5 inches (125 mm) nominal and 29 inches (735 mm) nominal above the finish floor....
-
1002.6.2 Transfer Height
The height of transfer device seats shall be 14 inches (355 mm) minimum and 24 inches (610 mm) maximum measured from the load and unload surface....
-
12204(a) Issuance of guidelines
(a) Issuance of guidelines Not later than 9 months after July 26, 1990, the Architectural and Transportation Barriers Compliance Board shall issue minimum guidelines that shall supplement...
-
2.4.1. Replacement Costs
The Final RA estimates the costs to replace captioning and audio description hardware and devices over the time frame of the analysis. ...
-
3.3.3 Clear Floor Width
Neither the DfT or DETR studies collected data on occupied width but did measure the unoccupied device width....
-
§ 36.311(a) Use of wheelchairs and manually powered mobility aids
A public accommodation shall permit individuals with mobility impairments to use wheelchairs, scooters, walkers, crutches, canes, braces, or similar devices in any areas open to pedestrian...
-
2.1.4. Venue Type
The number of hardware units and individual devices required by the rulemaking are the building blocks of the cost estimation for the average movie theater of each venue type. ...
-
SEC. 506. TECHNICAL ASSISTANCE. 42 USC 12206
SEC. 506. TECHNICAL ASSISTANCE. 42 USC 12206.
-
How do I assist a passenger with a disability?
How do I assist a passenger with a disability? Ask the passenger how you can best assist him or her. A passenger with a disability has the most information about his or her...
-
Sec. 12206. Technical assistance. [Section 507]
[See subsections ...]
-
§ 38.23(c)(1) Design load
(1) Design load. Ramps 30 inches or longer shall support a load of 600 pounds, placed at the centroid of the ramp distributed over an area of 26 inches by 26 inches, with a safety...
-
§ 38.23(c)(7) Stowage
(7) Stowage. A compartment, securement system, or other appropriate method shall be provided to ensure that stowed ramps, including portable ramps stowed in the passenger area, do...
-
§ 38.25 Doors, steps and thresholds
[See subsections ...]
-
§ 38.125(a)
(a)
-
3.3. Scoping Requirements
This section outlines the estimated number of hardware units and individual devices required for each venue type. ...
-
Chapter 4: Implications for standards and design
[See subsections ...]
-
§382.57(b)(3)
., print boarding passes/bag tags, accept payment for flight amenities such as seating upgrades/meals/WiFi access, rebook tickets, etc.), you must ensure that the accessible kiosks provide...
-
§ 382.57(b)(3)
., print boarding passes/bag tags, accept payment for flight amenities such as seating upgrades/meals/WiFi access, rebook tickets, etc.), you must ensure that the accessible kiosks provide...