Points of entry to bleacher seating may include, but are not limited to, cross aisles, concourses, vomitories, and entrance ramps and stairs....
Search Results "Ramp Surface"
-
11B-221.2.3.2 Vertical dispersion
-
1. Question: What is the minimum width needed for a non-level boarding railroad passenger station platform to meet the accessibility requirements of the Americans with Disabilities Act (ADA)?
lift platform has been made to accommodate various lifting mechanism designs.1 The lifting platform cannot be more than 3 inches above the platform in the down position with a connecting ramp...
-
SDC Bollard Post with Push Plate or Touch Panel
Practical solution for surface mount or in-ground installation....
-
Mockett PCS38-94 Clamp-On Power Grommet
It clips onto desks or work surfaces, and sits up and off desk for chic added touch. Standard configuration: Three electrical outlets rated 15A/125VAC and two Category 5e data ports....
-
American Standard Yorkville 1.6 gpf Right Height Elongated Pressure Assisted Toilet
Floor-mounted, back-outlet toilet combination bowl and tank less seat Pressure-assisted siphon jet action EverClean® Surface Elongated 16-1/2" high bowl for accessible...
-
American Standard Cadet 1.6 gpf Right Height Elongated Pressure Assisted Toilet
Combination bowl and tank, less seat 12" (305mm) rough EverClean® Surface Elongated bowl Pressure-assisted siphon jet flush action 16-1/2" rim height...
-
308.3.2 Obstructed High Reach
Operable parts of fuel dispensers shall be permitted to be 54 inches (1370 mm) maximum measured from the surface of the vehicular way where fuel dispensers are installed on existing curbs...
-
Alterations To An Area Containing A Primary Function
include, but are not limited to – §36.403(c)(1)(i) Remodeling merchandise display areas or employee work areas in a department store; §36.403(c)(1)(ii) Replacing an inaccessible floor surface...
-
704.9 Vertical separation of openings
The unexposed surface temperature limitations specified in ASTM E 119 shall not apply to the flame barriers or vertical separation unless otherwise required by the provisions of this code...
-
G. Sleeping Areas
Accessible cots have a sleeping surface at approximately the same height above the floor as the seat of a wheelchair (17 to 19 inches above the floor)....
-
F216.13 Trailhead Signs
The technical requirements in 1017.11 require the signs to include information on the length of the trail or trail segment; surface type; typical and minimum tread width; typical and minimum...
-
1016.1 General
The technical requirements address the surface of outdoor recreation access routes, passing spaces, and resting intervals (1016.2); the clear width of outdoor recreation access routes (1016.3...
-
Location
An accessible route never has curbs or stairs, must be at least 3- feet wide, and has a firm, stable, slip-resistant surface....
-
Suggested best practices for architects and other design professionals
architects and other design professionals As the construction industry works to develop standards for construction tolerances related to specific materials and applications for accessible surfaces...
-
Signage
Signs should not be made of reflective materials such as brass, silver, gold, glass, or mirrored surfaces unless there is an additional properly located sign that complies with the Standards...
-
Location
An accessible route never has curbs or stairs, must be at least 3- feet wide, and has a firm, stable, slip-resistant surface....
-
308.3.2 Obstructed High Reach
Operable parts of fuel dispensers shall be permitted to be 54 inches (1370 mm) maximum measured from the surface of the vehicular way where fuel dispensers are installed on existing curbs...
-
106.5.45 Primary Function
a primary function include, but are not limited to: (i) Remodeling merchandise display areas or employee work areas in a department store; (ii) Replacing an inaccessible floor surface...
-
Value Contrast (slide 9)
Fixed Surfaces To show where vertical and horizontal surfaces meet is very important. To show edges is very important....
-
Telescopes and Periscopes
Whenever a telescope or periscope is provided, ensure that a separate telescope or periscope is available for use from a standing position (60 inches above the floor or ground surface is...
-
Trail Slopes
Cross slopes—the side-to-side slope of a trail tread (figure 131)—provide drainage to keep water from ponding and damaging the trail, especially on unpaved surfaces....
-
2.3.2 IR Receivers
In these instances, the receiving diode can be placed within an oblong lens on the top of the headband, for presumably 360 degree reception, or appear as a rounded protuberance on the surface...
-
III. Summary of Comments
Survey,3 including equipment characteristics that affect patients ability to access and use medical equipment, such as: dimensions of the equipment (e.g. height, width, length,) contact surfaces...
-
B. The ADA Standards for Accessible Design
Section 904.2 requires that “[a]ll portions of counters required to comply with 904 shall be located adjacent to a walking surface complying with 403.” 2010 Standards § 904.2....
