meet is the equivalent of the WCAG 1.0 standard...
Search Results "Qualification Standard"
-
1. Technical Standard for Web Site Accessibility
-
1630.16(b)(4)
(4) May hold an employee who engages in the illegal use of drugs or who is an alcoholic to the same qualification standards for employment or job performance and behavior to which the entity...
-
§1630.16(b)(4)
(4) May hold an employee who engages in the illegal use of drugs or who is an alcoholic to the same qualification standards for employment or job performance and behavior to which the entity...
-
Kurt Knight: Development of VA Standards
I’m just going to give a little overview of VA’s standards website, a little discussion about how we go about developing the standards and implementing them, and a little about the issues...
-
SECTION 1.2 BUILDING STANDARDS COMMISSION
[See subsections ...]
-
SECTION 1.2 BUILDING STANDARDS COMMISSION
[See subsections ...]
-
§1607.5 General standards for validity studies.
set forth in the technical standards of these guidelines, section 14 below....
-
68.100. Technical Standards and Technical Memoranda
37 TexReg 677; amended effective August 1, 2020. 45 TexReg 5166) (a) The Texas Commission of Licensing and Regulation adopts by reference the 2012 Edition of the Texas Accessibility Standards...
-
Stairway Handrails Requirements in the ADA Standards (§504)
Stairway Handrails Requirements in the ADA Standards (§504) Protruding Objects The ADA Standards address hazards posed by protruding objects, such as standpipe valves, along...
-
Small entities potentially affected by proposed standards
The proposed standards do not impose any mandatory requirements on health care providers or medical device manufacturers....
-
608.5.2 Standard Roll-In Type Shower Compartments
In standard roll-in type shower compartments, the controls, faucets, and shower spray unit shall be located above the grab bar, but no higher than 48 inches (1220 mm) above the shower floor...
-
b) Historic Curb Ramp Design Standards
b) Historic Curb Ramp Design Standards 72....
-
(3) the City's curb ramp design standard
(3) the City's curb ramp design standard utilized between 1994 and 2004 pursuant to which it constructed curb ramps with a V inch lip at the base in violation of federal disability access...
- American Standard Acrylic Seated Safety Shower
-
§1607.14 Technical standards for validity studies.
The following minimum standards, as applicable, should be met in conducting a validity study....
-
608.3.2 Standard Roll-In Type Shower Compartments
Where a seat is provided in standard roll-in type shower compartments, grab bars shall be provided on the back wall and the side wall opposite the seat....
-
8. Revisions to Exceptions under 508 Standards
There is no general rule in the existing 508 Standards that agencies provide assistive technology at all employee workstations; rather, these standards merely require compatibility with...
- American Standard - Faucet Replacement
-
608.5.2 Standard Roll-In Type Shower Compartments
In standard roll-in type shower compartments, the controls, faucets, and shower spray unit shall be located above the grab bar, but no higher than 48 inches (1220 mm) above the shower floor...
-
2. Follow the Accessibility Standards for Play Areas
Follow the Accessibility Standards for Play Areas The 2010 Americans with Disabilities Act (ADA) Standards for Accessible Design apply to state and local governments (Title II) and places...
-
ADDITIONAL INFORMATION ABOUT THE 2010 STANDARDS
ADDITIONAL INFORMATION ABOUT THE 2010 STANDARDS 18. What is the Department's approach going to be to ensuring compliance with the new regulation pertaining to pool lifts?...
-
608.2.2 Standard Roll-In Type Shower Compartments
608.2.2 Standard Roll-In Type Shower Compartments....
-
12101(a)(5)
effects of architectural, transportation, and communication barriers, overprotective rules and policies, failure to make modifications to existing facilities and practices, exclusionary qualification...
-
E103.4 508 Standards (Section-by-Section Analysis)
The term “508 Standards” is defined in order to provide consistent cross-reference within the standards to all chapters that apply to Section 508-covered federal entities, namely: 508 Chapters...