Maximum g levels and head injury criteria (HIC) were measured....
Search Results "Measuring Technique"
Filters
Commonly Searched Documents
-
Test Procedures
-
a. Tests and Examinations
Tests and Examinations Accommodations may be needed to assure that tests or examinations measure the actual ability of an individual to perform job functions, rather than reflecting limitations...
-
Notes:
Given the differing shapes of mammography devices, defining the dimensions in relationship to each other with a static measurement point for the breast platform assures accessibility despite...
-
Back Support: ADA Standard Section 903.4
Back support shall be 2½ inches (64 mm) maximum from the rear edge of the seat measured horizontally. Advisory 903.4 Back Support....
-
11B-308.3.1 Unobstructed
Operable parts of fuel dispensers shall be permitted to be 54 inches (1372 mm) maximum measured from the surface of the vehicular way where fuel dispensers are installed on existing curbs...
-
11B-406.5.12 Detectable warnings
The detectable warning shall extend the full width of the curb ramp (exclusive of flared sides) and shall extend either the full depth of the curb ramp or 24 inches (610 mm) deep minimum measured...
-
11B-407.2.2.3 Audible signals
The audible signal and verbal annunciator shall be 10 dB minimum above ambient, but shall not exceed 80 dB, measured at the hall call button. Exceptions: Reserved. Reserved....
-
ADA Checklist for Existing Facilities
One person can take measurements and the other person can fill out the checklist and take photos....
-
D. Election Day Compliance Review
In the materials provided to each Chief Election Official for Election Day, the City will include a checklist of the temporary measures to be implemented on Election Day at each polling...
-
Scales
health care to individuals with mobility disabilities as well as illustrated examples of accessible medical equipment, room and office configurations, and lifting and transfer equipment and techniques...
-
National Safety Council (NSC)
Working to make the world measurably safer, NSC advances this mission by engaging businesses, government agencies, elected officials and the public to help prevent the fifth leading cause...
-
R&D Workshop Trim-A-Slab Intro Video
Watch the videos in this series for detailed information on planning, measuring, and installing Trim-A-Slab, the easiest to install of any expansion joint repair....
-
Suggested accessibility guidelines for exterior concrete surfaces
Other tolerances and measurement protocols are given using various methods but these are for interior surfaces....
-
11B-604.8.1.1 Size
Wheelchair accessible compartments shall be 60 inches (1524 mm) wide minimum measured perpendicular to the side wall, and 56 inches (1422 mm) deep minimum for wall hung water closets and...
-
8 [§§ 4.3.3; 4.3.7]
The measurement should extend from where the ramp run meets the level sidewalk (at the lower end of the arrow) to the opposite edge of the sidewalk (where the sidewalk meets the grass)....
-
608.2.1 Transfer Type Shower Compartments
Transfer type shower compartments shall be 36 inches (915 mm) by 36 inches (915 mm) clear inside dimensions measured at the center points of opposing sides and shall have a 36 inch (915...
-
609.4 Position of Grab Bars
Grab bars shall be installed in a horizontal position, 33 inches (840 mm) minimum and 36 inches (915 mm) maximum above the finish floor measured to the top of the gripping surface, except...
-
E102.3 ANSI/IEEE (Section-by-Section Analysis)
E102.3 ANSI/IEEE (Section-by-Section Analysis) ANSI/IEEE C63.19-2011, American National Standard for Methods of Measurement of Compatibility between Wireless Communications Devices and...
-
5.3.2.1 Size
The clear floor or ground space shall be 60 inches (1525 mm) wide minimum measured parallel with the back of the pit toilet, and 56 inches (1420 mm) deep minimum measured parallel to the...
-
C. Training
As part of its training programs for Election Coordinators and Election Judges, the Board will provide training concerning temporary remedial measures, including: (a) why such measures are...
-
5.3.2.1 Size
The clear floor or ground space shall be 60 inches (1525 mm) wide minimum measured parallel with the back of the pit toilet, and 56 inches (1420 mm) deep minimum measured parallel to the...
-
609.4 Position of Grab Bars
Grab bars shall be installed in a horizontal position, 33 inches (840 mm) minimum and 36 inches (915 mm) maximum above the finish floor measured to the top of the gripping surface, except...
-
§ 38.23(b)(6) Platform surface
The platform shall have a minimum clear width of 28 1/2 inches at the platform, a minimum clear width of 30 inches measured from 2 inches above the platform surface to 30 inches above the...
-
§ 38.83(b)(6) Platform surface
The lift platform shall have a minimum clear width of 28 1/2 inches at the platform, a minimum clear width of 30 inches measured from 2 inches above the lift platform surface to 30 inches...
