In residential dwelling units with mobility features where receptacles are provided in a kitchen at a corner work surface, one receptacle shall be located 36 inches (915 mm) from either...
Search Results "Ramp Surface"
-
11B-205.1 General
-
11B-205.1 General
In residential dwelling units with mobility features where receptacles are provided in a kitchen at a corner work surface, one receptacle shall be located 36 inches (915 mm) from either...
- Bradley 1.5 Gallon Facial Tissue Receptacle 359
- Rebuilding Together Kent County - Chestertown, MD
- Pressalit Care VALUE Support Arm Fixed Height Swing Grab Bar with Leg
- Bradley Soap & Towel Dispenser Shallow Multi-Purpose Unit 1471
-
Camp Shelters
Ensure that the surface of the clear floor or ground space at the open entrance side of the shelter and the floor of the shelter is firm, stable, and does not slope more than 2 percent (...
-
2.2.2 Structural Anthropometry (i.e. Body and WhMD Dimensions)
Seat support surface plane (defined by four corner points and one point at the interface of the occupant & seat surface i.e. compressed seat surface) Informs the 3-D digital model...
- American Specialties Coat and Bumper Hook 0714
- Bobrick Clothes Hook with Bumper B-212
- Viking Talk-A-Phones ETP-400V and ETP-400DV, Panel Phone E-1600A-TP-EWP
- Bradley Towel Dispenser 250-33
-
11B-704.4.1 Height
When in use, the touch surface of TTY keypads shall be 34 inches (864 mm) minimum above the finish floor. [S.H. ...
-
Sections 505.10.2 and 505.10.3
Commenters noted that the 2010 Standards will require handrail gripping surfaces with a circular cross section to have an outside diameter of 2 inches, and that this requirement would impose...
-
604.7 Dispensers
paper dispensers are installed above the side wall grab bar, the outlet of the toilet paper dispenser must be 48 inches (1220 mm) maximum above the finish floor and the top of the gripping surface...
-
Baby Changing Tables
In addition, convenience fixtures, such as baby changing tables, must be accessible to persons with disabilities under scoping provisions for operable parts (205) and work surfaces (226)...
-
M303.2.2 Width (Section-by-Section Analysis)
an exception in the final rule that permits wheelchair spaces on raised platforms to be 32 inches wide minimum with edge protection no higher than 4 inches, measured from the platform surface...
-
Technical Memorandum TM 2013-22 Storage (Kitchens and Kitchenettes)
Counter surfaces shall not be considered shelf space nor used to satisfy the requirements of 804.5....
-
1017.4 Passing Spaces
at shorter intervals if the clear tread width is less than 60 inches (1525 mm), where a trail is: --Heavily used; or --A boardwalk or otherwise not at the same level as the ground surface...
-
CONTENTS
Increasing number of Health Care Providers are Transitioning to Adjustable Height Tables Available data do not support departing from the currently accepted standard of 19-Inch transfer surface...
-
Implementation Challenges for Interiors (slides 16 and 17)
In the past, [we] have been required to have truncated cones covering the entire surface. For someone in a wheelchair, that is literally hell....
-
Disorienting Spaces (slide 7)
It’s actually a flat surface, and then going into the lovely, also very easy-to-navigate checkerboard flooring pattern....
-
Protruding Objects on Beach Access Routes
as signs that extend into the clear width area of a beach access route or resting interval and are between 27 inches (685 millimeters) and 80 inches (2,030 millimeters) above the travel surface...
-
1017.4 Passing Spaces
at shorter intervals if the clear tread width is less than 60 inches (1525 mm), where a trail is: • Heavily used; or • A boardwalk or otherwise not at the same level as the ground surface...