The color of the borderlines, hatched lines, and letters shall contrast with that of the surface of the access aisle....
Search Results "Transfer Surface Height"
-
11B-812.7.2 Marking
-
11B-809.10.5.1 Clear floor space
The edge of the clear floor space shall be flush with the control wall surface....
-
11B-812.7.2 Marking
The color of the borderlines, hatched lines, and letters shall contrast with that of the surface of the access aisle....
-
11B-809.10.5.1 Clear floor space
The edge of the clear floor space shall be flush with the control wall surface....
-
Utilities at Recreation Sites
When the surface is unpaved or not built with boards, grades up to 1:33 (3 percent) are allowed if needed for proper drainage....
-
1008 Play Areas
The play area specifications address accessible routes, ground level and elevated play components, play structures, and ground surfaces....
-
Section 2. Finished grade
"Finished grade" means the ground surface of the site after all construction, levelling, grading, and development has been completed....
-
f-ii
Is the change in level from the floor to the lift surface ramped or beveled? [ADA Standards §§ 4.11.2, 4.5.2] Yes No...
-
A7
Is the width of the curb ramp surface at least 36 inches (not counting the side flares)? [ADA Standards § 4.7.3] Yes No...
-
B7-a
Is the curb ramp surface at least 36 inches wide, excluding flared sides? [ADA Standards § 4.7.3] Yes No...
-
903.7 Wet Locations
Where installed in wet locations, the surface of the seat shall be slip resistant and shall not accumulate water....
-
BOAT LAUNCH RAMP
[DSA-AC] A sloped surface designed for launching and retrieving trailered boats and other water craft to and from a body of water....
-
11B-705.1.1 General
Detectable warnings shall consist of a surface of truncated domes and shall comply with Section 11B-705....
-
BOAT LAUNCH RAMP
[DSA-AC] A sloped surface designed for launching and retrieving trailered boats and other water craft to and from a body of water....
-
Excel Dryer, Inc. XLERATOReco® Hand Dryer
Graphite Surface Automatic Hand Dryer XL-SP-ECO** Custom Special Paint Surface...
-
608 Shower Compartments
Section 608 addresses transfer showers and roll-in showers and provides specifications for size and clearances, grab bars, seats, operable parts, shower spray units, thresholds, and enclosures...
-
803.1 General
Section 903.5 requires dressing room bench seats to be installed so that they are at the same height as a typical wheelchair seat, 17 inches (430 mm) to 19 inches (485 mm)....
-
604 Water Closets and Toilet Compartments
These include requirements for space at water closets (604.3), seat height (604.4), and grab bars (604.5)....
-
803.1 General
Section 903.5 requires dressing room bench seats to be installed so that they are at the same height as a typical wheelchair seat, 17 inches (430 mm) to 19 inches (485 mm)....
-
803.1 General
Section 903.5 requires dressing room bench seats to be installed so that they are at the same height as a typical wheelchair seat, 17 inches (430 mm) to 19 inches (485 mm)....
-
11B-603.5 Accessories
ETA Editor's Note The 2013 CBC 11B-603.5 limitation on the height of accessories at toilet rooms is more stringent than 2010 ADAS. ...
-
407.12.2.2 Obstructed Side Reach (Section-by-Section Analysis)
Section-by-Section Analysis) This section proposes that, where the operable part is located more than 10 inches, but not more than 24 inches, behind the vertical reference plane, the height...
-
4.10.6* Door Protective and Reopening Device
The device shall be capable of completing these operations without requiring contact for an obstruction passing through the opening at heights of 5 in and 29 in (125 mm and 735 mm) above...
-
Vertical Clearance [4.6.5]
Vertical clearance of at least 98 inches is based on the height necessary for personally-owned vans....
