Reflective & Transparent Surfaces can be Dangerous Vertical Surfaces (slide 4) Two examples are shown of hazards from reflective and transparent vertical surfaces....
Search Results "Door Surface"
Filters
Commonly Searched Documents
-
Eunice Noell-Waggoner, IES, LC. Value, Contrast and Reflections
-
Literature Cited
ASTM F1292 Standard Specification for Impact Attenuation of Surface Systems Under and Around Playground Equipment, ASTM, West Conshohocken,PA 19428 American Society for Testing and Materials...
-
ADA Sign Depot Elevator Door Jamb Floor Level Braille Sign - 4" x 4" - Tactile Sign
ADA Elevator Tactile Braille Floor Number Sign ADA compliant non-glare matte finish ADA compliant font and tactile (1/32 inch raised) Star and Numbers ADA...
-
11B-803.6 Mirrors
Mirrors shall be installed with the bottom edge of the reflecting surface 20 inches (508 mm) maximum above the finish floor or ground....
-
1011.2.4 Openings
Openings in the clear ground space surface shall not allow the passage of a sphere more than 1/2 inch (13 mm) in diameter. Advisory 1011.2.4 Openings. ...
-
1011.2.4 Openings
Openings in the clear ground space surface shall not allow the passage of a sphere more than 1/2 inch (13 mm) in diameter. Advisory 1011.2.4 Openings....
-
11B-803.6 Mirrors
Mirrors shall be installed with the bottom edge of the reflecting surface 20 inches (508 mm) maximum above the finish floor or ground....
-
11B-803.6 Mirrors
Mirrors shall be installed with the bottom edge of the reflecting surface 20 inches (508 mm) maximum above the finish floor or ground....
-
Tent Pads and Tent Platforms
Accessible surfaces for pitching tents may or may not be at ground level....
-
Addendum A: List of Terms
Non-level Transfer- A transfer where the transfer surface is higher or lower than the wheelchair seat to floor height....
-
Accessible Slopes
Put the level on the surface in the direction you are measuring. ...
-
Slope
The incline of a surface....
-
Slope
The incline of a surface. ...
-
Tools and Documentation
The following tools are needed for the 2016 Checklist: a metal tape measure at least 20 feet long a digital level or a bubble level that is at least 24 inches long a door pressure...
-
§ 36.207(b)
the residence covered under paragraph (a) of this section extends to those elements used to enter the place of public accommodation, including the homeowner´s front sidewalk, if any, the door...
-
Special Technical Provisions for Alterations to Existing Buildings and Facilities [4.1.6(3)]
Special provisions also address stairs, elevators, doors, toilet rooms, assembly areas, platform lifts, and dressing rooms....
-
§ 38.53(d)(2) Exception
At key stations, the horizontal gap between at least one door of each such vehicle and the platform shall be no greater than 3 inches....
-
§ 38.73(d)(2) Exception
At key stations, the horizontal gap between at least one door of each such vehicle and the platform shall be no greater than 3 inches....
-
Study Population
As of May, 2014, 76 subjects participated in our study; however, not all of the subjects traveled over every surface....
-
11B-504.8 Floor identification
required by Chapter 10, Section 1023.9 complying with Sections 11B-703.1, 11B-703.2, 11B-703.3 and 11B-703.5 shall be located at the landing of each floor level, placed adjacent to the door...
-
604.3.2 Overlap
When the door to the toilet room is placed directly in front of the water closet, the water closet cannot overlap the required maneuvering clearance for the door inside the room....
-
Hall Lanterns [4.10.4]
(Note that in-car lanterns increase door opening time since timing begins after doors open wide enough for the lantern to be visible)....
-
R305.2.4 Pedestrian Refuge Islands
At cut-through pedestrian refuge islands, detectable warning surfaces shall be placed at the edges of the pedestrian island and shall be separated by a 610 mm (2.0 ft) minimum length of...
-
11B-705.1.1.3 Color and Contrast
Detectable warning surfaces at transit boarding platform edges, bus stops, hazardous vehicular areas, reflecting pools, and track crossings shall comply with Section 11B-705.1.1.3.1....
