It is made with high-strength aluminum that will never rust or corrode and has an extruded slip-resistant surface to increase safety....
Search Results "Door Surface"
Filters
Commonly Searched Documents
-
EZ-ACCESS Transitions® Modular Entry Ramp
-
Chapter 9: Built-In Elements
Chapter 9 covers built-in elements, including dining surfaces and work surfaces (902), benches (903), and sales and service counters (904)....
-
Handrail Extensions
ADAAG does not require handrails on sloped surfaces that have a rise of less than 6 inches or a projection less than 72 inches, or a slope of 1:20 (5%) or less....
-
Acknowledgments
Acknowledgments The development of objective surface measurement devices and objective surface testing was conducted with funding from the National Center for Medical Rehabilitation Research...
-
D5. Raised Threshold
If there is a raised threshold, is it no higher than 3/4 inch at the door and beveled on both sides?...
-
R305.2.3 Blended Transitions
On blended transitions, detectable warning surfaces shall be placed at the back of curb....
-
Gratings [4.5.4]
These requirements apply to gratings located in any walking surface, including courtyards and plazas, not just those on accessible routes....
-
1133A.4.1 Repositionable countertops
Repositionable countertops shall comply with the following: Sinks and work surfaces required by Section 1133A.4 shall be designed to enable repositioning to a minimum height of 28...
-
3.2 Study Limitations and Other Issues
warning surface and the luminance contrast of the warning surface with adjacent surfaces....
-
11B-805 Medical care and long-term care facilities
Accessible patient amenities such as the turning radius, door maneuvering areas, their toilet/bathing room and their wardrobe are dependent upon whether it is an "accessible room" required...
-
Location and Size
The side rails are 20 inches minimum in length, 6 inches minimum in height above the table surface, and 1 inch measured horizontally from the adjacent edge of the table surface....
-
Boat Slips: ADA Standard Section 1003.2.1
Where handrail extensions are provided on gangways or transition plates, the handrail extensions shall not be required to be parallel with the ground or floor surface. 7....
-
11B-1003.2.1 Boat slips
The vertical distance is 10 feet (3050 mm) between the elevation where the gangway departs the landside connection and the elevation of the pier surface at the lowest water level....
-
AJW Architectural Products U674 C-fold/Multifold Towel Dispenser & Waste Receptacle Combination w/ Extended Waste - Recessed
Towel dispenser is vanity mounted Product Specs Mechanism Guide / Body: Fabricated of #22 gauge stainless steel that controls paper dispensing by means of 2 spring loaded dispensing doors...
-
PEMKO 4" Carpet Separator Threshold No. 2364
This is frequently required when carpet is installed under a fire door....
-
PEMKO 1 3/8" Carpet Separator Threshold No. 1951
This is frequently required when carpet is installed under a fire door....
-
PEMKO 1 3/4" Carpet Separator Threshold No. 236
This is frequently required when carpet is installed under a fire door....
-
PEMKO 6" Carpet Separator Threshold No. 2366
This is frequently required when carpet is installed under a fire door....
-
PEMKO 2 1/2" Carpet Separator Threshold No. 174
This is frequently required when carpet is installed under a fire door....
-
State of California Disability Access Services (DAS) - Boost Your Business: Physical Access, Technical Assistance & CASp
Boost Your Business Video Chapters: YouTube Channel Introduction Parking Path of Travel Ramps Curb Ramps Doors Halls and Fountains...
-
Transfer Devices for Use with Amusement Rides: ADA Standard Section 1002.6
Where possible, designers are encouraged to locate the transfer device seat no higher than 17 to 19 inches 430 to 485 mm) above the load and unload surface....
-
11B-1002.6 Transfer devices for use with amusement rides
Where possible, designers are encouraged to locate the transfer device seat no higher than 17 to 19 inches (430 to 485 mm) above the load and unload surface....
-
Gamco Recessed Towel Dispenser - TD-4
Description Unit fabricated of type 304 stainless steel with exposed surfaces having a #4 satin-finish....
-
Gamco Recessed Mini-Towel Dispenser and Waste Receptacle Combination - TW-3
All welded construction with all exposed surfaces having a #4 satin finish. One piece seamless flange provided with 1/4" (6mm) return for rigidity....
