Search Results "Counter Height"

• Federal Documents > Standards > ABA Accessibility Standard for GSA Facilities Pocket Guide
  504.2 Treads and Risers

  All steps on a flight of stairs shall have uniform riser heights and uniform tread depths. Risers shall be 4 inches (100 mm) high minimum and 7 inches (180 mm) high maximum....

• State and Local Documents > Codes and Standards > 2012 Florida Accessibility Code
  504.2 Treads and Risers

  All steps on a flight of stairs shall have uniform riser heights and uniform tread depths. Risers shall be 4 inches (100 mm) high minimum and 7 inches (180 mm) high maximum....

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.1.2 Transfer Surface High Height Recommendations for M301 and M302

  5.1.2 Transfer Surface High Height Recommendations for M301 and M302 The Committee recommends an adjustable height range with an upper height measuring at least 25 inches....

• Research and History > Research Documents > Independent Wheelchair Transfers in the Built Environment: How Transfer Setup Impacts Performance Phase 2: Final Report
  Transfer Protocols

  Like protocol A her level height was recorded as her maximum height for this protocol....

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.1.1 Transfer Surface Height Adjustability Recommendation for M301 and M302

  5.1.1 Transfer Surface Height Adjustability Recommendation for M301 and M302 The Committee recommends adjustable height in small, virtually continuous increments....

• Rulemaking Process Documents > NPRMS > 36 CFR Part 1195 Proposed Accessibility Standards for Medical Diagnostic Equipment NPRM - Preamble
  Height

  The Access Board is considering whether 6 inches minimum and 19 inches maximum above the transfer surface would be an appropriate height for transfer supports on diagnostic equipment used...

• Federal Documents > Standards > 2010 ADA Standards
  Height: ADA Standard Section 704.4.1

  Advisory 704.4.1 Height....

• Federal Documents > Standards > 2010 ADA Standards
  Height: ADA Standard Section 1009.5.3

  The height of the transfer platform shall comply with 1009.4.2....

• State and Local Documents > Codes and Standards > 2012 Florida Accessibility Code
  231.4 Visiting Areas

  231.4 Visiting Areas. Visiting areas shall comply with 231.4.

• Federal Documents > Standards > ABA Accessibility Standard for GSA Facilities Pocket Guide
  F231.4 Visiting Areas

  Visiting areas shall comply with F231.4.

• State and Local Documents > Codes and Standards > 2013 California Standards for Accessible Design Pocket Guide
  11B-231.4 Visiting areas

  Visiting areas shall comply with 11B-231.4. 

• State and Local Documents > Codes and Standards > 2012 Texas Accessibility Standards
  231.4 Visiting Areas

  Visiting areas shall comply with 231.4.

• State and Local Documents > Codes and Standards > 2013 California Standards for Accessible Design Pocket Guide
  1133A.4.1 Exceptions

  Exceptions: Stone, cultured stone and tiled countertops may be used without meeting the repositioning requirements. Two 15-inch (381 mm) wide minimum breadboards may...

• State and Local Documents > Codes and Standards > 2013 California Standards for Accessible Design Pocket Guide
  1133A.4, Item 1

  1.      A minimum linear length of 30 inches (762 mm) of countertop shall be provided for the kitchen sink installation.

• Federal Documents > Standards > 1991 ADA Standards for Accessible Design
  7.3(3)

  (3) Signage identifying accessible check-out aisles shall comply with 4.30.7 and shall be mounted above the check-out aisle in the same location where the check-out number or type of...

• Federal Documents > Standards > 1991 ADA Standards for Accessible Design
  4.7.2 Slope

  Slopes of curb ramps shall comply with 4.8.2. The slope shall be measured as shown in Fig. 11. Transitions from ramps to walks, gutters, or streets shall be flush and free of abrupt...

• Federal Documents > Standards > Uniform Federal Accessibility Standards (UFAS)
  4.7.2 SLOPE

  Slopes of curb ramps shall comply with 4.8.2. The slope shall be measured as shown in Fig. 11. Transitions from ramps to walks, gutters, or streets shall be flush and free of abrupt...

• State and Local Documents > Codes and Standards > 2016 California Standards for Accessible Design Pocket Guide - Eff. Jan. 1, 2017
  11B-231.4 Visiting areas

  Visiting areas shall comply with 11B-231.4.  

• State and Local Documents > Codes and Standards > 2016 California Standards for Accessible Design Pocket Guide - Eff. Jan. 1, 2017
  1133A.4, Item 1

  1. A minimum linear length of 30 inches (762 mm) of countertop shall be provided for the kitchen sink installation.

• State and Local Documents > Codes and Standards > 2019 California Standards
  11B-231.4 Visiting areas

  Visiting areas shall comply with Section 11B-231.4.

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  5.1.4 Transfer Surface Height Measurement for M301 and M302

  5.1.4 Transfer Surface Height Measurement for M301 and M302 The Committee recommends capturing the transfer surface height at the highest point of the seat in an uncompressed state, inclusive...

• Federal Documents > Standards > ABA Accessibility Standard for GSA Facilities Pocket Guide
  602.4 Spout Height

  Spout outlets shall be 36 inches (915 mm) maximum above the finish floor or ground.

• State and Local Documents > Codes and Standards > 2012 Texas Accessibility Standards
  602.4 Spout Height

  Spout outlets shall be 36 inches (915 mm) maximum above the finish floor or ground.