features: Flushometer PERMEX(R) Synthetic Rubber Diaphragm with Dual Filtered Fixed Bypass ADA compliant metal oscillating Non-Hold-Open Handle with Triple Seal Handle Packing 1"...
Search Results "9-1-1 Service"
Filters
Commonly Searched Documents
-
Sloan WETS 2050.1001-1.28 Manual HET Flushometer and HET Wall Hung Water Closet
-
AJW Architectural Products U646 Series Lever Operated Roll Towel Dispenser & Waste Receptacle Combination - Recessed
Flange: Fabricated of #22 ga stainless steel finished to match cabinet with 1/4" returns, (No miters or welds) Cabinet Back: Fabricated of stainless steel formed for rigidity with multiple...
-
GE Cafe™ Series 30" Free-Standing Gas Double Oven with Convection Range CGS990SETSS
BTU Precise Simmer Burner (1) 5,000 BTU/140F degree simmer Tri-Ring Burner (1) 20,000 BTU / 140F degree simmer All-Purpose Burners (1) 9,100...
-
Introduction
Three Federal laws – the Individuals with Disabilities Education Act (IDEA),1 Title II of the Americans with Disabilities Act of 1990 (ADA) (Title II),2 and Section 504 of the Rehabilitation...
-
BACKGROUND
. § 12188(b)(1)(A)(i) and 28 C.F.R. § 36.502....
-
INVESTIGATION AND FINDINGS
The ADA prohibits discrimination on the basis of disability in the full and equal enjoyment of the goods, services, facilities, privileges, advantages, or accommodations by a public accommodation...
-
ENFORCING AGENCY
[DSA-AC, HCD 1 & HCD 2] Enforcing Agency is the designated department or agency as specified by statute or regulation....
-
1630.2(l)(3)
(3) Has none of the impairments defined in paragraphs (h)(1) or (2) of this section but is treated by a covered entity as having a substantially limiting impairment....
-
§382.21(b)
(b) In assessing whether the passenger's condition poses a direct threat, you must apply the provisions of §382.19(c)(1) - (2) of this subpart....
-
§ 1194.26(b)
(b) If a product utilizes touchscreens or touch-operated controls, an input method shall be provided that complies with §1194.23 (k) (1) through (4)....
-
505.5 Clearance
Clearance between handrail gripping surfaces and adjacent surfaces shall be 1½ inches (38 mm) minimum. Figure 505.5 Handrail Clearance...
-
Sec. 469.003(a)(3)
(3) a building leased for use or occupied, in whole or in part, by the state under a lease or rental agreement entered into on or after January 1, 1972;...
-
6. Ramps
Ramps 4.8 Accessible routes with slopes greater than 1:20....
-
225(g)(2) Jurisdiction of Commission
(2) Jurisdiction of Commission After referring a complaint to a State under paragraph (1), the Commission shall exercise jurisdiction over such complaint only if...
-
C1-f
If the slope of part of the accessible route is more than 1:20, does it meet the following requirements for an accessible ramp? Yes No...
-
C1-a
[ADA Standards § 4.1.2(1), 4.3] Yes No...
-
405.7.1 Slope
EXCEPTION: Slopes not steeper than 1:48 shall be permitted....
-
11B-405.7.1 Slope
Exception: Slopes not steeper than 1:48 shall be permitted....
-
11B-703.7.2.6.4 Edges and corners
Corners of signs shall have a minimum radius of 1/8 inch (3.2 mm)....
-
1.2.4
1.2.4 When local horizontal discontinuities and vertical alignments are measured according to Section 1.1.9 a recommended tolerance is ±1/8 in. (3 mm)....
-
Can curb ramps overlap access aisles?
No, access aisles, as well as vehicle pull-up spaces, cannot have changes in level other than slopes not exceeding 1:48....
-
CLEAR FLOOR SPACE
[DSA-AC & HCD 1-AC] The minimum unobstructed floor or ground space required to accommodate a single, stationary wheelchair and occupant....
-
11B-405.7.1 Slope
Exception: Slopes not steeper than 1:48 shall be permitted....
-
ACCESSIBLE
[DSA-AC & HCD 1-AC] A site, building, facility, or portion thereof that is approachable and usable by persons with disabilities in compliance with this code....
