[See subsections ...]
Search Results "Patient Room"
Commonly Searched Documents
-
SECTION 1135A LAUNDRY ROOMS
-
11B-224.1.3 Range of accommodations
Accessible guest rooms or suites shall be dispersed among the various classes of sleeping accommodations to provide a range of options applicable to room sizes, costs, and amenities provided...
-
Single-User Toilet Rooms: Split Plumbing
Single-User Toilet Rooms: Split Plumbing Water closets and lavatories can be located on opposing walls....
-
5.4.10 Transfer Support Fittings for Equipment Used in a Supine, Prone, Side-Lying, or Seated Position
The transfer supports shall not rotate when locked in place for patient transfer or use....
-
224 Transient Lodging Guest Rooms
The minimum number of guest rooms required to be accessible in transient lodging facilities is covered in section 224....
-
§ 36.406(c)(1) Guest rooms
(1) Guest rooms. Guest rooms with mobility features in places of lodging subject to the transient lodging requirements of 2010 Standards shall be provided as follows –...
-
11B-224.8.1 More than 25-bed sleeping rooms
In sleeping rooms with more than 25 beds, a minimum of 5 percent of the beds shall have clear floor space complying with Section 11B-806.2.3....
-
19 Inch Low Height
in the United States, we reviewed the CDC National Ambulatory Care Survey, and found that there are approximately 639,000 exam rooms in the United States today....
-
5.4.10 Transfer Support Fittings Recommendations for M301 and M302
The Committee recommends transfer supports not rotate when locked in place for patient transfer or use....
-
11B-809.10 Toilet and bathing rooms
[See subsections ...]
-
11B-803.6 Mirrors
Mirrors shall be installed with the bottom edge of the reflecting surface 20 inches (508 mm) maximum above the finish floor or ground. Mirrors shall be full length with a reflective...
-
5.8 Wheelchair Spaces Recommendations for M303 Diagnostic Equipment Used by Patients Seated in a Wheelchair
5.8 Wheelchair Spaces Recommendations for M303 Diagnostic Equipment Used by Patients Seated in a Wheelchair...
-
806 Transient Lodging Guest Rooms
806 Transient Lodging Guest Rooms...
-
M101.2 Application
Where diagnostic equipment is designed to support more than one patient position, the standards for each patient position supported shall be applied to the equipment....
-
Number of Accessible Guest Rooms
A hotel and motel trade group opposed any increase in the number of guest rooms required to be accessible and submitted a study it commissioned on the usage of such rooms....
-
M302.4.1 Clearance in Base
The base of the diagnostic equipment shall provide a clearance 39 inches (990 mm) wide minimum, 6 inches (150 mm) high minimum measured from the floor, and 36 inches (915 mm) deep...
-
M302.4.1 Clearance in Base
The base of the equipment shall provide a clearance 44 inches (1120 mm) wide minimum, 6 inches (150 mm) high minimum measured from the floor, and 36 inches (915 mm) deep minimum...
-
11B-224.1.2 Guest room doors and doorways
[2010 ADA Standards] 224.1.2 Guest Room Doors and Doorways....
-
Comparison of Single-User Toilet Room Layouts: 2A, 2B, and 2C
This increases the room depth from Plan−1A....
-
Scoping [4.1.3(21), 4.1.6(3)(h)]
Scoping [4.1.3(21), 4.1.6(3)(h)] ADAAG requires access to 5% of each "type" of dressing room in each location....
- Brewer Assist Power Procedure Table™
-
11B-222.3 Mirrors
Where mirrors are provided in dressing, fitting or locker rooms without individual compartments, at least one of each type shall comply with Section 11B-803.6....
-
11B-222.3 Mirrors
Where mirrors are provided in dressing, fitting or locker rooms without individual compartments, at least one of each type shall comply with Section 11B-803.6....
-
11B-222.3 Mirrors
Where mirrors are provided in dressing, fitting or locker rooms without individual compartments, at least one of each type shall comply with Section 11B-803.6....