(1) First, a public accommodation should take measures to provide access to a place of public accommodation from public sidewalks, parking, or public transportation....
Search Results "Measuring Instrument"
-
Sec.36.304(c)(1)
-
BS8300:2001 Research
It is also not clear what was measured if the chair had no armrests or slanted armrests....
-
405.3 Cross Slope
Cross slope is measured the same way as slope is measured (i.e., the rise over the run)....
-
810.2.2 Dimensions
Bus stop boarding and alighting areas shall provide a clear length of 96 inches (2440 mm) minimum, measured perpendicular to the curb or vehicle roadway edge, and a clear width of 60 inches...
-
405.3 Cross Slope
Cross slope is measured the same way as slope is measured (i.e., the rise over the run)....
-
R308.1.1.1 Dimensions
Boarding and alighting areas shall provide a clear length of 2.4 m (8.0 ft) minimum, measured perpendicular to the curb or street or highway edge, and a clear width of 1.5 m (5.0 ft) minimum...
-
Sec.36.304(c)(3)
(3) Third, a public accommodation should take measures to provide access to restroom facilities....
-
§ 36.304(c)(3)
(3) Third, a public accommodation should take measures to provide access to restroom facilities....
-
608.2.1 Transfer Type Shower Compartments
Transfer type shower compartments shall be 36 inches (915 mm) by 36 inches (915 mm) clear inside dimensions measured at the center points of opposing sides and shall have a 36 inch (915...
-
Definitions
that a polling place is compliant with the 2010 ADA Standards for Accessible Design (“2010 Standards”) on Election Day, whether such compliance is achieved through permanent architectural measures...
-
11B-810.2.2 Dimensions
Bus stop boarding and alighting areas shall provide a clear length of 96 inches (2438 mm) minimum, measured perpendicular to the curb or vehicle roadway edge, and a clear width of 60 inches...
-
11B-703.4.1 Height above finish floor or ground
Tactile characters on signs shall be located 48 inches (1219 mm) minimum above the finish floor or ground surface, measured from the baseline of the lowest Braille cells and 60 inches (1524...
-
Future Work
The devices that are on the market to measure roadway roughness are not applicable to sidewalk and pedestrian surfaces because they either use accelerometers to measure the surface profile...
-
NSS Questions and Concerns
, 13 accessibility areas and resources were categorized to provide comparison between the DOJ and ARC (Red Cross) instruments....
-
11B-809.1.2 Viewing devices
residential dwelling units with mobility features shall also provide a lower viewing device 42 inches (1067 mm) minimum and 43 inches (1092 mm) maximum above the finish floor or ground, measured...
-
UDI
Measurements were made with rulers and tape measures but no information is given on the accuracy and reliability of these techniques....
-
604.3.1 Size
Clearance around a water closet shall be 60 inches (1525 mm) minimum measured perpendicular from the side wall and 56 inches (1420 mm) minimum measured perpendicular from the rear wall....
-
1.2.1 Walks and other non - ramp surfaces
When overall running slope for walks is measured according to Section 1.1.3 a recommended tolerance for running slope is +1%....
-
§ 37.151(a)(2)
(2) The entity determines that it cannot make measured progress toward compliance in any year before full compliance is required....
-
Background
Further, industry standards, specifications, and measurement procedures do not even address some measures important to facility usability in new construction, such as how to measure the...
-
405.3 Cross Slope
Cross slope is measured the same way as slope is measured (i.e., the rise over the run)....
-
7.4.6 Tread Obstacles
Tread obstacles on trails shall not exceed 2 inches (50 mm) in height measured vertically to the highest point. ...
-
Access-Able Designs Stationary Dressing Bench DST-101
Measures 48"W x 24"D back measures 48”W x 24”H (custom sizes available) 5 year warranty....
-
Definitions
that a polling place is compliant with the 2010 ADA Standards for Accessible Design (“2010 Standards”) on Election Day, whether such compliance is achieved through permanent architectural measures...
