Handrails may be located in a recess if the recess is 3 inches (76 mm) maximum deep and 18 inches (457 mm) minimum clear above the top of the handrail....
Search Results "Feasibility (Technical, Infeasible, Structural, Maximum Extent)"
-
11B-505.5 Clearance
-
608.3.2 Standard Roll-In Type Shower Compartments
Grab bars shall be installed 6 inches (150 mm) maximum from adjacent walls....
-
1005.2.1 Height
At least 25 percent of the railings, guards, or handrails shall be 34 inches (865 mm) maximum above the ground or deck surface....
-
703.2.5 Character Height
Character height measured vertically from the baseline of the character shall be 5/8 inch (16 mm) minimum and 2 inches (51 mm) maximum based on the height of the uppercase letter "I"....
-
IV. ALTERATIONS AND NEW CONSTRUCTION
The ILA will provide any necessary technical assistance throughout the term of this Settlement Agreement, but the United States retains the right to ultimately determine whether the Events...
-
Factors to Consider in Planning For & Administering an ADA Facilities Compliance Plan
Fourth, consider the administrative structure of your organization in developing your compliance strategy....
- ADA Checklist: Health Care Facilities and Service Providers
-
5. Exception from the Requirements of M302 for Weight Scales with Integral Seats
The MDE NPRM proposed that diagnostic equipment which could be used by patients in multiple positions must comply with the technical criteria for all positions in which it could be used...
- BTX Intelligent Fashion Test For Drapery Track, 40Kg Load
-
M102.1 Defined Terms (Section-by-Section Analysis)
defined: health care provider, breast platform, patient support surface, transfer supports, positioning supports, prone position, supine position, examination tables, diagnostic purposes, maximum...
-
5.4.6 Transfer Support Gripping Surface Cross Section and Clearances for M301, M302, and M305.2
disabilities to firmly grasp the grab bars and support themselves during transfers: Grab bars with circular cross sections must have an outside diameter of 1¼ inches minimum and 2 inches maximum...
-
Newly Constructed Tabled Intersections That Contain Pedestrian Street Crossings With Yield or Stop Control (Section-by-Section Analysis)
Newly Constructed Tabled Intersections That Contain Pedestrian Street Crossings With Yield or Stop Control (Section-by-Section Analysis) The 2 percent maximum cross slope requirement...
-
Addendum F: Relative Height Differences
Adjustable Height No Grab Bars/No Backrest Maximum Height (n=71) .300 3.5 5.00 9.00 13.7...
-
11B-809.8 Doors
., concrete, brick, flagstone) may have a maximum change in height from the interior landing of 4 inches (102 mm)....
- Magnuson Group SLOPE Waste Receptacles
- Seating Solutions ADA Platforms, Ramps & Stairs
- Hussey Seating Company Flip-Up Armrest
-
11B-1008.2.5.2 Elevated
The rise for any ramp run connecting elevated play components shall be 12 inches (305 mm) maximum....
-
1134A.8, Item 1
The top of the fixture rim shall be a maximum of 34 inches (864 mm) above the finished floor....
-
11B-703.2.5 Character height
Character height measured vertically from the baseline of the character shall be 5/8 inch (15.9 mm) minimum and 2 inches (51 mm) maximum based on the height of the uppercase letter “I”. ...
-
1009.2.1 Pool Lift Location
Where multiple pool lift locations are provided, no more than one pool lift shall be required to be located in an area where the water level is 48 inches (1220 mm) maximum....
-
1009.5.4 Transfer Steps
Transfer step height shall be 8 inches (205 mm) maximum....
-
407.4.8.2.1 Signal Type
EXCEPTION: For elevators other than destination-oriented elevators that have a rated speed of 200 feet per minute (1 m/s) or less, a non-verbal audible signal with a frequency of 1500 Hz maximum...