WAD-2230 Square front (1-1/2") solid surface lavatory deck The lavatory deck shall be constructed of Aquasurf® molded cast polymer densified solid surface material composed of polyester...
Search Results "Transfer Surface"
Commonly Searched Documents
- Willoughby Industries 2230 Series AquaDeck Lavatory Deck
- Bradley Towel Dispenser 250-15
- Bradley Tumbler Lock Towel Dispenser 252
- Inclusion Solutions Temporary Lot Paint (Case of 12) Blue
-
B. The ADA Standards for Accessible Design
Section 904.2 requires that “[a]ll portions of counters required to comply with 904 shall be located adjacent to a walking surface complying with 403.” 2010 Standards § 904.2....
-
C. Raised Porches Are Part Of the Store That Must Be Made Accessible and Located On An Accessible Route
Pursuant to Chapter 3, accessible spaces must have compliant floor surfaces, compliant turning space, and compliant clear floor space, among other requirements. 2010 Standards, §§ 301-309...
- American Standard Decorum 0.125 gpf High Efficiency Urinal Top Spud
-
1. Executive Summary
access routes to be provided within pedestrian circulation paths located in the public right-of-way, and would establish proposed technical provisions for the width, grade, cross slope, and surface...
-
1. Public Right-of-Way
In particular, Kirola noted that while travelling around San Francisco, she encountered bumps and/or uneven surfaces along: (1) the east side of Fulton Street ("Fulton") between Fillmore...
-
2. Electronic (Digital) Level
Note: Some architects use a "rise over run" formula to calculate the slope of a surface....
-
11B-1003.3.2 Boarding pier clearances
At high water, the entire chain is floating and a transition plate connects the first float to the surface of the launch ramp....
-
1003.3.2 Boarding Pier Clearances
At high water, the entire chain is floating and a transition plate connects the first float to the surface of the launch ramp....
-
Value Contrast (slide 9)
Fixed Surfaces To show where vertical and horizontal surfaces meet is very important. To show edges is very important....
-
1003.3.2 Boarding Pier Clearances
At high water, the entire chain is floating and a transition plate connects the first float to the surface of the launch ramp....
-
Telescopes and Periscopes
Whenever a telescope or periscope is provided, ensure that a separate telescope or periscope is available for use from a standing position (60 inches above the floor or ground surface is...
-
Trail Slopes
Cross slopes—the side-to-side slope of a trail tread (figure 131)—provide drainage to keep water from ponding and damaging the trail, especially on unpaved surfaces....
-
2.3.2 IR Receivers
In these instances, the receiving diode can be placed within an oblong lens on the top of the headband, for presumably 360 degree reception, or appear as a rounded protuberance on the surface...
- Willoughby Industries WBL-2320 Ligature-resistant Behavioral Healthcare Lavatory System
-
308.3.2 Obstructed High Reach
Operable parts of fuel dispensers shall be permitted to be 54 inches (1370 mm) maximum measured from the surface of the vehicular way where fuel dispensers are installed on existing curbs...
-
106.5.45 Primary Function
a primary function include, but are not limited to: (i) Remodeling merchandise display areas or employee work areas in a department store; (ii) Replacing an inaccessible floor surface...
-
Alterations To An Area Containing A Primary Function
include, but are not limited to – §36.403(c)(1)(i) Remodeling merchandise display areas or employee work areas in a department store; §36.403(c)(1)(ii) Replacing an inaccessible floor surface...
-
704.9 Vertical separation of openings
The unexposed surface temperature limitations specified in ASTM E 119 shall not apply to the flame barriers or vertical separation unless otherwise required by the provisions of this code...
-
308.3.2 Obstructed High Reach
Operable parts of fuel dispensers shall be permitted to be 54 inches (1370 mm) maximum measured from the surface of the vehicular way where fuel dispensers are installed on existing curbs...
-
F216.13 Trailhead Signs
The technical requirements in 1017.11 require the signs to include information on the length of the trail or trail segment; surface type; typical and minimum tread width; typical and minimum...