Ramps that change direction between runs at landings shall have a clear landing 60 inches (1525 mm) minimum by 72 inches (1829 mm) minimum in the direction of downward travel from the upper...
Search Results "Travel Center Facility"
-
11B-405.7.4 Change in direction
-
disABILITY Resource Center (dRC) - Knoxville, TN
Who We Are/What We Do dRC is a Center for Independent Living. (CIL) We are a community-based non-residential program of services....
-
11B-801.1 Scope
Facilities covered by these requirements are also subject to the requirements of the other chapters....
-
11B-801.1 Scope
Facilities covered by these requirements are also subject to the requirements of the other chapters....
-
Where do I measure for a handrail extension?
The result is that where the extension begins to curve away from the direction of travel, the handrail becomes obstructed. ...
-
Segway Human Transporter
Table 22 shows how the Segway characteristics compare with those values of the design vehicle, the bicycle, in the AASHTO Guide for the Development of Bicycle Facilities.(2) 2....
-
Symmetry Limited Use/Limited Application (LU/LA) Elevator
The Elevation is ideal for applications up to six stops and 25 feet (standard) or 40 feet (with approved variance) of travel....
-
Section 36.207 Places of Public Accommodation Located in Private Residences (Preamble, Section-by-Section Analysis)
For instance, a home or a portion of a home may be used as a day care center during the day and a residence at night....
-
PUBLIC USE AREAS
[HCD 1-AC] Interior or exterior rooms or spaces of a building or facility that are made available to the general public and do not include common use areas....
-
Amusement Attraction
Any facility, or portion of a facility, located within an amusement park or theme park which provides amusement without the use of an amusement device....
-
indoo.rs® Indoor Navigation Solution App
Travel Indoor navigation provides travelers at airports, railway-stations, etc. with mobile assistance; for example guiding them to the right place – specific gates, VIP lounges, information...
-
R302.3.2 Shared Use Paths
provision at R302.3.2 that would require a pedestrian access route to be provided for the full width of a shared use path since shared use paths are typically two-directional and path users travel...
-
Road Closure Drawings
Often, foot travel is allowed beyond the restriction device. When foot travel is encouraged on the other side of the barrier, passage for someone in a wheelchair must be provided....
-
Trail Type
A category that reflects the predominant trail surface and general mode of travel accommodated by a trail....
-
Skating Skill and Performance
For example, novice skaters typically travel more slowly and have a narrower sweep width than advanced skaters.(8) Skaters choose among several different techniques to stop, often based...
-
12.1 Q...How is the individual building test performed for additional stories, to determine if those stories must also be treated as ground floors?
determining whether a non-elevator building has more than one ground floor, the point of measurement for additional ground floors, after the first ground floor has been established, is at the center...
-
7(2)(b)(iv)
In locations where toilets are adjacent to walls or bathtubs, the center line of the fixture is a minimum of 1'6" from the obstacle....
-
11B-503.3.3 Marking
The area within the borderlines shall be marked with hatched lines a maximum of 36 inches (914 mm) on center in a color contrasting with that of the aisle surface....
-
1134A.8, Item 4.3
The knee and toe space shall be centered on the fixture, and shall comply with Section 1138A.2....
-
A4.13.9 Door Hardware
To be effective, they should cover the door width, less approximately 2 in (51 mm), up to a height of 16 in (405 mm) from its bottom edge and be centered across the width of the door....
-
Side Approach
Recommendation: The clear floor space should be centered on the ATM unit....
-
1134A.8, Item 4.3
The knee and toe space shall be centered on the fixture, and shall comply with Section 1138A.2....
-
11B-608.2.3 Alternate roll-in type shower compartments
Alternate roll-in type shower compartments shall be 36 inches (914 mm) wide and 60 inches (1524 mm) deep minimum clear inside dimensions measured at center points of opposing sides....
-
R218 Doors, Doorways, and Gates
Except for shared use paths, doors, doorways, and gates provided at pedestrian facilities shall comply with section 404 of Appendix D to 36 CFR to 36 CFR part 1191....
