Wheelchair accessible compartments shall be 60 inches (1524 mm) wide minimum measured perpendicular to the side wall, and 56 inches (1422 mm) deep minimum for wall hung water closets...
Search Results "Maximum Reach Depth"
Filters
Commonly Searched Documents
-
11B-604.8.1.1 Size
-
R405.2.2 Maximum Depth
R405.2.2 Maximum Depth. Toe clearance shall extend 635 mm (2.1 ft) maximum under an element....
-
306.2.2 Maximum Depth
306.2.2 Maximum Depth. Toe clearance shall extend 25 inches (635 mm) maximum under an element....
-
Re: Section 307 Protruding Objects
Yes, it is a protruding object hazard based solely on section 307, but so is the (code compliant) lavatory with its (required) 29" high front edge, and the 8" deep (code compliant)...
-
Section 307 Protruding Objects
This dryer protrudes more than 4" from the wall and is greater than 27" above the finish floor. Isn't this a violation of Section 307 Protruding Objects?
-
1008.4.2 Clear Floor or Ground Space
The following table provides guidance on reach ranges for children seated in wheelchairs. These dimensions apply to either forward or side reaches....
-
1008.4.2 Clear Floor or Ground Space
The following table provides guidance on reach ranges for children seated in wheelchairs. These dimensions apply to either forward or side reaches....
-
F104.1 Dimensions
Dimensions that are not stated as "maximum" or "minimum" are absolute....
-
104.1 Dimensions
Dimensions that are not stated as "maximum" or "minimum" are absolute....
-
104.1 Dimensions
Dimensions that are not stated as "maximum" or "minimum" are absolute....
-
Routes and Destinations: ADA Standard Section 810.6.2
Signs covered by this requirement shall, to the maximum extent practicable, be placed in uniform locations within the system....
-
R405.3.2 Maximum Depth
R405.3.2 Maximum Depth. Knee clearance shall extend 635 mm (2.1 ft) maximum under an element at 230 mm (9 in) above the finish surface....
-
11B-306.3.2 Maximum depth
Knee clearance shall extend 25 inches (635 mm) maximum under an element at 9 inches (229 mm) above the finish floor or ground....
-
11B-810.6.2 Routes and destinations
Signs covered by this requirement shall, to the maximum extent practicable, be placed in uniform locations within the system....
-
Card Catalogs and Magazine Displays [8.4]
Requirements for fixed counters and tables [4.32] specify a surface height (34 inches maximum) and knee clearance below appropriate for extended use as a writing/work surface....
-
306.3.2 Maximum Depth
306.3.2 Maximum Depth. Knee clearance shall extend 25 inches (635 mm) maximum under an element at 9 inches (230 mm) above the finish floor or ground....
-
Door King Inc. 1520/1524 Stand Alone Card Readers
The model 1520 provides users with a full feature single door stand-alone access control system. The 1520 is available with a built-in proximity card reader (DK Prox, AWID or HID) or...
-
R302.5.4 Physical Constraints
R302.5.4 Physical Constraints. Where compliance with R302.5.1 or R302.5.2 is not practicable due to existing terrain or infrastructure, right-of-way availability, a notable natural...
-
Special Technical Provisions for Alterations to Existing Buildings and Facilities [4.1.6(3)]
Section 4.1.6(3) recognizes certain allowances where technical feasibility is encountered, such as steeper slopes for short ramps. Special provisions also address stairs, elevators,...
-
§ 35.151(b)(3)
(3) Alterations to historic properties shall comply, to the maximum extent feasible, with the provisions applicable to historic properties in the design standards specified in § 35.151(c...
-
4.10.12(3)
All floor buttons shall be no higher than 48 in (1220 mm), unless there is a substantial increase in cost, in which case the maximum mounting height may be increased to 54 in (1370 mm),...
-
M201.2 General Exception
Diagnostic equipment subject to M201.2 shall comply to the maximum extent practicable....
-
Vending Machines and Other Equipment [5.8]
Recommendation: It is recommended that the operable portions be within accessible reach ranges....
