Additions and alterations to existing buildings or facilities, including leased buildings or facilities, shall comply with F202....
Search Results "Fire-Building Surface"
-
F202.1 General
-
§100.201 Entrance
Entrance means any access point to a building or portion of a building used by residents for the purpose of entering....
-
M302.3.1 Transfer Supports (Section-by-Section Analysis)
Based on the restructure of the transfer surface provisions, described above in Section IV.B.1.b....
-
11B-206.4.8 Service entrances
If a service entrance is the only entrance to a building or to a tenancy in a facility, that entrance shall comply with Section 11B-404....
-
4.1.7(1)(a)
(a) As a general rule, the accessibility provisions of part 4 shall be applied to "qualified" historic buildings and facilities....
-
Sargent 8300 Mortise Lock Exit Device
look Through-bolted trim for quiet operation and security Single door applications Double door application with Mortise Lock & Vertical Rod Device UL Fire...
-
Transfer Height
Transfer Height Ride seats designed for transfer must be between 14 and 24 inches above the load and unload area surface....
-
R304.5.2 Grade Breaks
Grade breaks shall not be permitted on the surface of ramp runs and turning spaces. Surface slopes that meet at grade breaks shall be flush....
-
11B-406.5.8 Counter slope
Counter slopes of adjoining gutters and road surfaces immediately adjacent to and within 24 inches (610 mm) of the curb ramp shall not be steeper than 1:20....
-
Allegion Schlage CS200-Series Mechanical Locks with Tubular Interconnect
Designed for applications ranging from military housing to multi-family and small hotel/motel buildings, the CS200-Series is a lock you can depend on. ...
-
Federal Elevator 360 Passenger Elevator
The 360 elevator is the affordable answer to overcome architectural barriers in three or four level office buildings, clubs, and meeting halls, where permitted by local code....
-
Cal-Royal Products Grade 1 Cylindrical Lockset Calypso CAL Series
Specifications: APPLICATIONS - For offices, schools, hospitals, apartments, hotel/motel, residential, commercial and public buildings....
-
Clear Tread Width and Passing Spaces for Outdoor Recreation Access Routes
Clear tread width means the width of the traveled surface on the ground and also above the ground between obstacles (figure 40)....
-
1012.5 Slope
The slope of the surface of parking spaces and pull-up spaces shall not be steeper than 1:48 in any direction....
-
904.3.2 Counter
The counter surface height shall be 38 inches (965 mm) maximum above the finish floor or ground....
-
5.1.8 Slope
The slope of the surface of the clear ground space shall not be steeper than 1:48 in any direction....
-
1012.5 Slope
The slope of the surface of parking spaces and pull-up spaces shall not be steeper than 1:48 in any direction....
-
11B-904.3.2 Counter
The counter surface height shall be 38 inches (965 mm) maximum above the finish floor or ground....
-
11B-904.3.2 Counter
The counter surface height shall be 38 inches (965 mm) maximum above the finish floor or ground....
-
CURB RAMP
A sloping prepared surface, intended for pedestrian traffic, which provides access between a walk or sidewalk and a surface located above or below an adjacent curb face....
-
11B-303.5 Warning curbs
Abrupt changes in level exceeding 4 inches (102 mm) in a vertical dimension between walks, sidewalks or other pedestrian ways and adjacent surfaces or features shall be identified by warning...
-
Transfer Height
Transfer Height The height of the transfer device must be between 14 and 24 inches above the load and unload area surface....
-
Openings [1018.6]
Openings are gaps in the surface of a beach access route....
-
Outdoor Conditions [4.8.8]
Exterior ramps must be designed so that water does not accumulate on the ramp or landing surface. A slope up to 2% is allowed at landings for adequate drainage....
