Swinging hoistway doors shall open and close automatically and shall comply with 404, 407.3.2 and 408.3.2....
Search Results "Shall"
-
408.3.2 Swinging Doors
-
903.7 Wet Locations
Where installed in wet locations, the surface of the seat shall be slip resistant and shall not accumulate water....
-
219.1 General
Assistive listening systems shall be provided in accordance with 219 and shall comply with 706....
-
408.4.6 Car Controls
Elevator car controls shall comply with 407.4.6. Control panels shall be centered on a side wall....
-
705.1 General
Detectable warnings shall consist of a surface of truncated domes and shall comply with 705....
-
213.3.4 Lavatories
Where lavatories are provided, at least one shall comply with 606 and shall not be located in a toilet compartment....
-
409.4.6 Car Controls
Elevator car control buttons shall comply with 409.4.6, 309.3, 309.4, and shall be raised or flush....
-
407.2.1.6 Keypads
Where keypads are provided, keypads shall be in a standard telephone keypad arrangement and shall comply with 407.4.7.2....
-
407.3.1 Type
Elevator doors shall be the horizontal sliding type. Car gates shall be prohibited....
-
206.1 General
Accessible routes shall be provided in accordance with 206 and shall comply with Chapter 4....
-
11B-405.9 Edge protection
Edge protection complying with 405.9.1 or 405.9.2 shall be provided on each side of ramp runs and at each side of ramp landings. Exceptions: 1. ...
-
F216.8 Toilet Rooms and Bathing Rooms
existing toilet rooms or bathing rooms do not comply with 603, directional signs indicating the location of the nearest toilet room or bathing room complying with 603 within the facility shall...
-
11B-603.4 Coat hooks, shelves and medicine cabinets
Coat hooks shall be located within one of the reach ranges specified in Section 11B-308....
-
Handrails
Handrail gripping surfaces shall be continuous along their length and shall not be obstructed along their tops and sides....
-
§8.32(e)
(e) Except as otherwise provided in this paragraph, the provisions of §§8.21(a) and (b), 8.22(a) and (b), 8.23, 8.25(a)(1) and (2), and 8.29 shall apply to facilities that are designed,...
-
11B-1009.2.4 Seat
The seat shall be rigid and shall have a back support that is at least 12 inches (305 mm) tall....
-
4.1.3(19)(a)
(a) In places of assembly with fixed seating accessible wheelchair locations shall comply with 4.33.2, 4.33.3, and 4.33.4 and shall be provided consistent with the following table:...
-
4.34.6.7* OVENS
Ovens shall comply with 4.34.6.2 and 4.34.6.3. Ovens shall be of the self-cleaning type or be located adjacent to an adjustable height counter with knee space below (see Fig. 52)....
-
Stairs
At the top, the extension shall be parallel with the floor or ground surface....
-
11B-405.9 Edge protection
Edge protection complying with 405.9.1 or 405.9.2 shall be provided on each side of ramp runs and at each side of ramp landings. Exceptions: 1....
-
§ 38.57(b)
(b) Handrails, stanchions, and seats shall allow a route at least 32 inches wide so that at least two wheelchair or mobility aid users can enter the vehicle and position the wheelchairs...
-
11B-405.9 Edge protection
Edge protection complying with 405.9.1 or 405.9.2 shall be provided on each side of ramp runs and at each side of ramp landings....
-
608.3 Grab Bars
Grab bars shall comply with 609 and shall be provided in accordance with 608.3....
-
216.8 Toilet Rooms and Bathing Rooms
existing toilet rooms or bathing rooms do not comply with 603, directional signs indicating the location of the nearest toilet room or bathing room complying with 603 within the facility shall...