There are no standards which specify the radiated level of light required at seat locations. At least one manufacturer (Audex) makes a light meter available for installers....
Search Results "Seat Height"
-
2.3.3 Issues
- HEWI Mirror 950.01.400
- Young Equipment Sales Vinyl Bleacher End Closures
-
11B-233.3.6 Graduate student and faculty housing at a place of education
806.2.3 of the 2010 Standards. 2) Facilities with more than 50 beds covered by this part that provide common use bathing facilities shall provide at least one roll-in shower with a seat...
-
11B-233.3.6 Graduate student and faculty housing at a place of education
806.2.3 of the 2010 Standards. 2) Facilities with more than 50 beds covered by this part that provide common use bathing facilities shall provide at least one roll-in shower with a seat...
- GameTime Thread the Needle Playground Equipment
- Inclusion Solutions Poll Star Voting Booth
-
SHELTERING
The height of the bed and the wheelchair seat are of similar height making it possible for this person to transfer from the wheelchair to the bed....
-
I. Background
The subject of this Agreement is the XL Center, a stadium located in Hartford, Connecticut, with a seating capacity of approximately 16,000....
- TotTurf® Synthetic Grass: Play Spaces
-
4.3.3 Clear Floor Area
for the minimum required size of spaces used by wheeled mobility users (e.g. platform/wheelchair lifts) and for spaces/locations that are designated for wheeled mobility users such as in seating...
- Kompan, Inc. ELE400021 - Blazer Spring Toy
-
Section G: Ramps
(§405.3) G3 Is the rise (height) for any ramp run 30" or less?...
-
11B-308.3.2 Obstructed high reach
Where a clear floor or ground space allows a parallel approach to an element and the high side reach is over an obstruction, the height of the obstruction shall be 34 inches (864 mm) maximum...
-
11B-703.7.2.6 Toilet and bathing facilities geometric symbols
When toilet and bathing facilities have doorway openings instead of doors, such as at airports or stadiums, the geometric identification symbol should be located at the proper height adjacent...
-
604.5 Grab Bars
must be sufficient to permit the installation of rear and side wall grab bars that fully meet all accessibility requirements including, but not limited to, required length, installation height...
-
QUESTION: WHAT CONSTITUTES AN ALTERATION TO A PLATFORM FOR PURPOSES OF TRIGGERING THE APPLICATION OF SECTION 37.42 REQUIREMENTS?
For example, if the platform height relative to the top of rail is raised, if the old surface is removed and/or a new surface put down, or if there is a reconstruction of or structural change...
-
E. Chapter 4: Boarding and Alighting
the technical requirements for the slope of ramps in non-rail vehicles by specifying a single standard (1:6) for maximum running slope applicable to ramps deployed to roadways or curb-height...
-
Interior Routes
INTERIOR ROUTES Floor and ground surfaces stable, firm and slip resistant. 11B-302.1 Carpet pile height 1/2 inch...
-
4.1.3(17)(a)
At least one public telephone per floor shall meet the requirements for a forward reach telephone3. 1 Additional public telephones may be installed at any height....
-
Interior Routes
INTERIOR ROUTES Floor and ground surfaces stable, firm and slip resistant. 11B-302.1 Carpet pile height 1/2 inch...
-
2.2 Key Measurement Variables and Procedures
Reaches and lifts: One-handed maximum reaches recorded at 5 different heights in three different directions for up to four different weight conditions (maximum of 60 reaches total). 4...
-
Guidelines
Tactile objects are tied closely to the exhibit’s interpretive theme and defy the same standardized approach that can be applied to an exhibit’s mounting height, door size and location,...
-
11B-405.5 Clear width
Handrails may project into the required clear width of the ramp at each side 3½ inches (89 mm) maximum at the handrail height. 3....