In shared use paths, the width of curb ramps runs and blended transitions shall be equal to the width of the shared use path....
Search Results "Transit Shelter"
Filters
Commonly Searched Documents
-
R304.5.1.2 Shared Use Paths
-
Cross Slope
Cross Slope The cross slopes of gangways, transition plates and floating piers that are part of an accessible route must be designed and constructed not to exceed a maximum of 2 percent...
-
Develop a Plan
Develop a Plan State and local governments were required to develop a Transition Plan six months after the ADA went into effect (1993!)....
-
§35.150(d)
(d) Transition plan. ...
-
Level boarding
If not using a lift or ramp to provide level boarding, the grantee must submit to FTA a demonstration of equivalent facilitation. (DOT ADA Regulation 49 C.F.R. 37.7(b) and DOT ADA...
-
Are self-evaluations and transition plans required to be updated?
As many people know, the self-evaluation was supposed to be conducted and the transition plan developed in the late part of the 20th century (1992-3). That’s a long time ago....
-
Figure 406.2 Counter Slope of Surface Adjacent to Curb Ramps – Drawing from the U.S. Access Board
-
II-5.6000 Time periods for achieving program accessibility
A public entity that employs 50 or more persons must develop a transition plan by July 26, 1992, setting forth the steps necessary to complete such changes....
-
K3
Tables can be relocated as needed during operation of the shelter....
-
5.1.2 Level or Sloped Entry
Camp shelters providing roll-in access shall have a level or sloped entry that complies with the FSORAG Outdoor Recreation Access Route technical provisions if the camp shelter is in a campground...
-
5.1.3 Slope
The slope of the surface of the clear floor or ground space inside the camp shelter shall not be steeper than 1:48 (2 percent) in all directions....
-
1014.3.2 Slope
The slope of the floor surface shall not be steeper than 1:48 in any direction. EXCEPTION: Where the floor surface is other than asphalt, concrete, or boards, slopes not steeper...
-
f-vi
f-vi. Are the controls and operating mechanisms usable with one hand without tight grasping, pinching, or twisting? [ADA Standards §§ 4.11.2, 4.27.4] Yes No
-
H25
H25. Is the clear width of the door at least 32 inches (measured between the face of the door and the edge of the opening) when the door is open 90 degrees? [ADA Standards §...
-
L1
L1. Is there a backup source of electrical power for the facility? Yes No
-
H9
H9. Are the drain and hot water pipes for this lavatory insulated or otherwise configured to protect against contact? [ADA Standards § 4.19.4] Yes No
-
f-v
f-v. Are the controls and operating mechanisms mounted no more than 54 inches above the floor for a side reach or 48 inches for a forward reach? [ADA Standards §§ 4.11.2,...
-
M8
M8. Is there at least 18 inches between the center of the toilet and the side of the adjacent lavatory? [ADA Standards § 4.16.2; Fig. 28] Yes No
-
H20
H20. Is the flush valve located on the wide side adjacent to the lavatory or is an automatic flush valve provided? [ADA Standards § 4.16.5] Yes No
-
M3
M3. Is the hardware (e.g., lever, pull, etc.) usable with one hand without tight grasping, pinching, or twisting of the wrist? [ADA Standards § 4.13.9] Yes No If No,...
-
J2
J2. If the drinking fountain is a floor-mounted unit, is there clear floor space at least 30 inches long x 48 inches wide (60 inches if it is in an alcove) for a side approach to the...
-
H5
H5. If there is a raised threshold, is it no higher than 3/4 inch at the door and beveled on both sides? [ADA Standards §§ 4.1.6(3)(d)(ii), 4.13.8] Yes No NA If...
-
B7
B7. If there is a curb between the access aisle and the accessible route to the building, is there a curb ramp that meets the following requirements: [ADA Standards §...
-
C2‒2
C2‒2. Are the undersides of exterior stairs enclosed or protected with a cane-detectable barrier so that people who are blind or have low vision will not hit their heads on the...
