H19. Is the top of the toilet seat 17 inches to 19 inches above the floor? [ADA Standards § 4.16.3] Yes No
Search Results "Transit Shelter"
Filters
Commonly Searched Documents
-
H19
-
M16
M16. Is the centerline of the toilet 18 inches from the adjacent side wall? [ADA Standards §§ 4.16.2; 4.17.3] Yes No
-
H28
H28. Is the surface of the toilet seat in this 36-inch-wide stall 17 to 19 inches above the floor? [ADA Standards §§ 4.16.3; 4.22.4] Yes No
-
M17
M17. Is the top of the toilet seat 17 to 19 inches above the floor? [ADA Standards § 4.16.3] Yes No
-
A7
A7. Is the width of the curb ramp surface at least 36 inches (not counting the side flares)? [ADA Standards § 4.7.3] Yes No
-
e-ii
e-ii. Is the running slope (up or down the ramp) no more than 1:12? [ADA Standards § 4.7.2] Yes No Note: 1:12 is one inch of vertical height for 12 inches of...
-
f-viii
f-viii. If the ramp or landing has a vertical drop-off on either side, is edge protection provided? [ADA Standards § 4.8.7] Yes No
-
B7-b
B7-b. Is the slope (up or down the ramp) no more than 1:12? [ADA Standards § 4.7.2] Yes No Note: 1:12 is one inch of vertical height for each 12 inches of length.
-
e-i
e-i. Is the curb ramp surface at least 36 inches wide, excluding flared sides? [ADA Standards § 4.7.3] Yes No
-
c-i
c-i. If Yes, is a ramp or sloped hallway provided? Yes No If Yes, go to question E1-d.
-
B7-a
B7-a. Is the curb ramp surface at least 36 inches wide, excluding flared sides? [ADA Standards § 4.7.3] Yes No
-
1132A.4.1, Item 1
1. Thresholds with a change in height of not more than ¼ inch (6.35 mm) may be vertical.
-
Value Contrast (slide 9)
Fixed Surfaces To show where vertical and horizontal surfaces meet is very important. To show edges is very important. And one place where this is really important, even though...
-
10.3.1(15)
(15) Where clocks are provided for use by the general public, the clock face shall be uncluttered so that its elements are clearly visible. Hands, numerals, and/or digits shall...
-
Thresholds [§404.2.5]
Thresholds [§404.2.5] The height of thresholds is limited to 1/2” in new construction. The edge must be beveled 1:2 maximum above a height of 1/4”. A maximum height of 3/4” is...
-
§ 37.147 Considerations during FTA review
In reviewing each plan, at a minimum FTA will consider the following:
-
1132A.4.1, Item 1
1. Thresholds with a change in height of not more than ¼ inch (6.35 mm) may be vertical.
-
§ 37.149 Disapproved plans
[See subsections ...]
-
Section 37.143 Paratransit Plan Implementation
Section 37.143 Paratransit Plan Implementation As already discussed under §37.135, the states will receive FTA recipient plans for recipients of funding under 49 U.S.C. 5311...
-
§ 38.179(a)
(a) New and used trams consisting of a tractor unit, with or without passenger accommodations, and one or more passenger trailer units, including but not limited to vehicles...
-
§8.24(d) Transition plan and time period for structural changes
(d) Transition plan and time period for structural changes....
-
a) Curb Ramps
Consistent with its Curb Ramp and Sidewalk Transition Plan, the City installs approximately 1,200 new curb ramps each year....
-
1014.3 Floor
This section requires the floor surface within camp shelters to be firm and stable and to slope not steeper than 1:48 in any direction....
-
Handrail Extensions
Handrail extensions are not required where gangways and transition plates connect and both are provided with handrails....