University of Michigan Transportation Research Institute (UMTRI) has been involved in wheelchair-occupant safety research for more than thirty years and Biosciences researchers and test...
Search Results "Testing"
- University of Michigan Transportation Research Institute
-
1630.15(b)(1)
It may be a defense to a charge of discrimination, as described in section 1630.10, that an alleged application of qualification standards, tests, or selection criteria that screens out...
-
§382.133(f)(2)
(2) Any applicable requirement for a manufacturer-affixed label to reflect that the device has been tested to meet requirements for medical portable electronic devices set by the FAA for...
-
711.2 Installation details
Insulation and coverings on or in the penetrating item shall not penetrate the assembly unless the specific material used has been tested as part of the assembly in accordance with this...
-
7. Medicine
For example, transit agencies should modify their policies to allow individuals to administer insulin injections and conduct finger stick blood glucose testing....
-
7. Medicine
For example, transit agencies should modify their policies to allow individuals to administer insulin injections and conduct finger stick blood glucose testing....
-
CONCLUSIONS
• Community mobility of the subjects as measured by total energy expenditure on the ADAAG course, level of fitness as measured by the PWC170 and grip strength tests, and the type of...
-
§ 38.159(b)(9) Platform deflection
(exclusive of vehicle roll or pitch) in any direction between its unloaded position and its position when loaded with 600 pounds (2665 N) applied through a 26 inch (660 mm) by 26 inch test...
-
2.4.3. Maintenance and Administrative Costs
The maintenance and administrative costs include, but are not limited to: Periodic ongoing maintenance, system testing, and cleaning of devices – Under heavy use from patrons, movie...
-
Slip Resistance
Since rating systems are unique to the test method, specific levels of slip resistance can only be meaningfully specified according to a particular measurement protocol....
- NetCentric Technologies Inc. CommonLook PDF Validator Software
- Voluntary Voting System Guidelines
- Inpro Corporation IPC® Designer Kickplates
-
ADDITIONAL RESOURCES
For more Federal government resources and information on HIV/AIDS, including about prevention, testing, treatment, research, and the National HIV/AIDS Strategy, visit http://www.aids.gov...
- Reeve-Irvine Research Center
-
Telecommunications Act
Testing adaptive equipment. — U.S. Department of Labor...
-
Wheelchair Work Measurement Method
Wheelchair work per meter values for straight and turning were determined for all test course surfaces except sand, under dry conditions using the Wheelchair Work Measurement Method in accordance...
-
RECOMMENDATIONS
RECOMMENDATIONS An objective test procedure for measuring the firmness and stability of surfaces with a portable device and performance specifications need to be accepted in order to...
-
Introduction to Guidelines
should consider the following factors: Where market research is undertaken, including individuals with disabilities in target populations of such research; Where product design, testing...
-
Polypavement
The surface started to show signs of cracking, sinking and softening after the first round of tests when the temperature was still mild and warm (June – August; 100 degree temps)....
-
Stabilizer
It was not until the testing conducted in March 2008 that the surface showed large signs of deterioration....
-
RESEARCH OBJECTIVES
Objectively measure the firmness and stability of the test surfaces; 3....
-
What is the minimum level of slip resistance required by the standards?
Some products are labeled with a rated level, but in the absence of a consensus test procedure, the standards do not set a minimum value. ...
-
§ 37.27(b)
The test of equivalence is the same as that provided in §37.105....