more than 3 degrees (exclusive of vehicle roll or pitch) in any direction between its unloaded position and its position when loaded with 600 pounds applied through a 26 inch by 26 inch test...
Search Results "Testing"
Commonly Searched Documents
-
§ 38.23(b)(9) Platform deflection
-
§ 38.125(b)(9) Platform deflection
not deflect more than 3 degrees (exclusive of car roll) in any direction between its unloaded position and its position when loaded with 600 pounds applied through a 26 inch by 26 inch test...
-
711.4.2 Membrane penetrations
Such penetrations shall not exceed an aggregate area of 100 square inches (64 500 mm2) in any 100 square feet (9.3 m2) of ceiling area in assemblies tested without penetrations....
-
Treatment of Data
Through further analysis, results of playground surface tests for firmness and stability were compared within surface categories and across surface categories to determine the mean, range...
-
Suggestion by Eldon Tipping
Tipping suggested that each ramp should be evaluated independently as a Random - Traffic Test Surface....
-
Acceptable SEWF Systems
Preliminary portable impact tests provided an indication of the cushioning performance of the stabilizing binder....
-
Appendix C Rotational Penetrometer Data Form
Beneficial Designs Serial num-ber: BDRP- Date of last calibration: Tire pressure set at 36 psi on (date): By: Date & Test...
- University of Michigan Transportation Research Institute
-
Selection of Locations
The 11 test plots were installed in a previously undisturbed wetlands area where the maximum running slope of any of the sections was 7.6 percent....
-
APPENDIX A
The site plan will be labeled with locations 1‒9 to identify the critical test areas. One copy will be kept on file with NCA. ...
-
1630.15(b)(1)
It may be a defense to a charge of discrimination, as described in section 1630.10, that an alleged application of qualification standards, tests, or selection criteria that screens out...
-
§382.133(f)(2)
(2) Any applicable requirement for a manufacturer-affixed label to reflect that the device has been tested to meet requirements for medical portable electronic devices set by the FAA for...
-
711.2 Installation details
Insulation and coverings on or in the penetrating item shall not penetrate the assembly unless the specific material used has been tested as part of the assembly in accordance with this...
-
7. Medicine
For example, transit agencies should modify their policies to allow individuals to administer insulin injections and conduct finger stick blood glucose testing....
-
7. Medicine
For example, transit agencies should modify their policies to allow individuals to administer insulin injections and conduct finger stick blood glucose testing....
-
CONCLUSIONS
• Community mobility of the subjects as measured by total energy expenditure on the ADAAG course, level of fitness as measured by the PWC170 and grip strength tests, and the type of...
-
§ 38.159(b)(9) Platform deflection
(exclusive of vehicle roll or pitch) in any direction between its unloaded position and its position when loaded with 600 pounds (2665 N) applied through a 26 inch (660 mm) by 26 inch test...
-
2.4.3. Maintenance and Administrative Costs
The maintenance and administrative costs include, but are not limited to: Periodic ongoing maintenance, system testing, and cleaning of devices – Under heavy use from patrons, movie...
-
Slip Resistance
Since rating systems are unique to the test method, specific levels of slip resistance can only be meaningfully specified according to a particular measurement protocol....
- NetCentric Technologies Inc. CommonLook PDF Validator Software
- Voluntary Voting System Guidelines
- Inpro Corporation IPC® Designer Kickplates
-
ADDITIONAL RESOURCES
For more Federal government resources and information on HIV/AIDS, including about prevention, testing, treatment, research, and the National HIV/AIDS Strategy, visit http://www.aids.gov...
- Reeve-Irvine Research Center