Swinging door or gate surfaces within 10 inches (254 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
Search Results "Swing"
Commonly Searched Documents
- 
    
  
  1132A.9 Smooth surface
  
- 
    
  
  1132A.9 Smooth surface
  Swinging door or gate surfaces within 10 inches (254 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door... 
- 
    
  
  Door Maneuvering Clearance
  Table 404.2.4.1 specifies maneuvering clearances for manual swinging doors and gates.... 
- 
    
  
  1132A.9 Smooth surface
  Swinging door or gate surfaces within 10 inches (254 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door... 
- 
    
  
  Grab Bars [4.16.4]
  Other designs may be possible under the provision of "equivalent facilitation" in 2.2 although movable or swing-away grab bars on the open side are not allowed as a substitute for the back... 
- 
    
  
  Doorways [4.8.4]
  Keeping the door swing clear of minimum landing dimensions is a good idea, especially at the bottom of ramps since people using wheelchairs may exit them with some force and speed.... 
- 
    
  
  Mirrors [4.19.6]
  Clear floor space (30 by 48 inches minimum) for a forward approach located outside the swing of doors should be provided at full-length mirrors.... 
- Landscape Forms Inc. FGP Trash Receptacle
- 
    
  
  604.8.1.2 Doors
  Toilet compartment doors shall not swing into the minimum required compartment area.... 
- 
    
  
  36 Inch Wide Stalls
  Out-swinging doors prevent obstruction of grab bars during entry and self-closing hinges keep one from having to reach back to close the door while using grab bars for support.... 
- 
    
  
  Example of a Single-User Bathroom (with Roll-in Shower)
  The door cannot swing into the clear floor space required at accessible fixtures.... 
- 
    
  
  Automatic Doors
  In the proposed rule, section 404.3.2 required that maneuvering clearances specified for swinging doors be provided at power-assisted doors and gates since their activation, unlike those... 
- 
    
  
  Findings
  For example, there may be swings designed to be on an accessible route and connected by the unitary surface. ... 
- Just Manufacturing Single Handle Deck Mount Faucet
- Stanley Hardware RP9401 Door Closer
- Spectrum Aquatics Portable Aspen Pool Lift
- Allegion LCN 1460 Series Surface Mounted Door Control
- 
    
  
  1010.1.9.7 Delayed egress locks
  For doors that swing in the direction of egress, the sign shall read: KEEP PUSHING. THIS DOOR WILL OPEN IN 15 [30] SECONDS.... 
- 
    
  
  Threshold Height
  An exception in original ADAAG that allowed a ¾ inch threshold at exterior sliding doors was removed in the proposed rule because products are available, including swinging doors, that meet... 
- 
    
  
  604.8.1.2 Doors
  Toilet compartment doors shall not swing into the minimum required compartment area. [ECTCR UFAS 4.17.5] Figure 604.8.1.2 Wheelchair Accessible Toilet Compartment Doors... 
- 
    
  
  703.4.2 Location
  characters shall be located so that a clear floor space of 18 inches (455 mm) minimum by 18 inches (455 mm) minimum, centered on the tactile characters, is provided beyond the arc of any door swing... 
- 
    
  
  703.4.2 Location
  characters shall be located so that a clear floor space of 18 inches (455 mm) minimum by 18 inches (455 mm) minimum, centered on the tactile characters, is provided beyond the arc of any door swing... 
- 
    
  
  604.8.1.2 Doors
  Toilet compartment doors shall not swing into the minimum required compartment area. Figure 604.8.1.2 Wheelchair Accessible Toilet Compartment Doors ... 
- 
    
  
  Clear Floor Space [4.35.2]
  Space is important so that users can turn around and exit through swinging or sliding doors. Benches can overlap turning space where clearance (9 inches minimum) is available for toes.... 
