Search Results "Door Surface"
-
Figure 407.4.1(b) Elevator Car Dimensions – Drawing from the U.S. Access Board
-
Figure 407.4.1(e) Elevator Car Dimensions – Drawing from the U.S. Access Board
-
Figure 407.4.1(d) Elevator Car Dimensions – Drawing from the U.S. Access Board
-
Figure 407.4.1(c) Elevator Car Dimensions – Drawing from the U.S. Access Board
-
Figure 407.4.1(a) Elevator Car Dimensions – Drawing from the U.S. Access Board
-
16. Opening Building Doors
For paratransit services, a passenger's request for the driver to open an exterior entry door to a building to provide boarding and/or alighting assistance to a passenger with a disability...
-
11B-233.3.1.2.6 Public housing facility site impracticality
ETA Editor's Note This section of the 2019 California Building Code was amended by the Division of the State Architect. The requirements in this section were previously found in...
-
Guest Rooms
Carpet causes resistance that makes rolling much more difficult than on the aforementioned surfaces....
-
Counter Surface Height
Specifications are provided for the counter surface height of check-out aisles, including the height of counter edge protection, which is limited to 2 inches above the counter surface (904.3.2...
-
2.3.4 Analysis of Door Use Difficulty
2.3.4 Analysis of Door Use Difficulty The measurement of door use performance was designed as a quasi-experimental study that involved systematically observing and coding WhMD user performance...
-
ADA Solutions, Inc. Cast in Place Tactile Surface Installation Video
This is an application and installation video of the Cast In Place detectable tactile surface....
-
4.1.6(3)(d) Doors
(d) Doors:...
-
11B-1009.5.5 Surface
The surface of the transfer system shall not be sharp and shall have rounded edges....
-
11B-1009.4.4 Surface
Surfaces of transfer walls shall not be sharp and shall have rounded edges....
-
11B-1009.4.4 Surface
Surfaces of transfer walls shall not be sharp and shall have rounded edges....
-
11B-1009.5.5 Surface
The surface of the transfer system shall not be sharp and shall have rounded edges....
-
11B-1009.4.4 Surface
Surfaces of transfer walls shall not be sharp and shall have rounded edges....
-
11B-1009.5.5 Surface
The surface of the transfer system shall not be sharp and shall have rounded edges....
-
11B-407.4.10.2 Surfaces
Support rails shall be smooth and any surface adjacent to them shall be free of sharp or abrasive elements....
-
11B-407.4.10.2 Surfaces
Support rails shall be smooth and any surface adjacent to them shall be free of sharp or abrasive elements....
-
11B-407.4.10.2 Surfaces
Support rails shall be smooth and any surface adjacent to them shall be free of sharp or abrasive elements....
-
5a. Ramp Surface
Is the ramp surface at least 36 inches wide, excluding flared sides? [ADA Stds 4.7.3] Yes _____ No _____...
