DEPARTMENT OF TRANSPORTATION 49 CFR Parts 37 and 38 [Docket OST–2006–23985] RIN 2105–AD54 Transportation for Individuals With Disabilities at Intercity, Commuter, and...
Search Results "Rail Vehicle"
Filters
Commonly Searched Documents
-
49 CFR Part 38 - Transportation for Individuals With Disabilities at Intercity, Commuter, and High Speed Passenger Railroad Station Platforms; Miscellaneous Amendments
-
11B-407.4.10.1 Location
Clearance between support rails and adjacent surfaces shall be 1½ inches (38 mm) minimum....
-
11B-407.4.10.1 Location
Clearance between support rails and adjacent surfaces shall be 1½ inches (38 mm) minimum....
-
11B-407.4.10.1 Location
Clearance between support rails and adjacent surfaces shall be 1½ inches (38 mm) minimum....
-
§ 37.93 One car per train rule
[See subsections ...]
-
11B-812.10.3 Point-of-sale devices
Where provided, point-of-sale devices shall comply with Sections 11B-707.2, 11B-707.3, 11B-707.7.2, and 11B-707.9.
-
11B-812.8.5 Drive-up
Drive-up EVCS shall not be required to be identified by an ISA.
-
12184(c)(2) Definition
(2) Definition As used in this subsection, the term "historical or antiquated rail passenger car" means a rail passenger car...
-
Can a single EV charger service two EV Accessible spots or does each spot have to have its own charger?
RESPONSE: A single multiport EV charger that can simultaneously charge two vehicles can be used to serve two EV spaces required to be accessible....
-
11B-407.4.10.3 Structural strength
Allowable stresses shall not be exceeded for materials used when a vertical or horizontal force of 250 pounds (1112 N) is applied at any point on the support rail, fastener, mounting device...
-
11B-407.4.10.3 Structural strength
Allowable stresses shall not be exceeded for materials used when a vertical or horizontal force of 250 pounds (1112 N) is applied at any point on the support rail, fastener, mounting device...
-
§ 38.175 High-speed rail cars, monorails and systems
[See subsections ...]
-
Looking at Cal Green 5.106.5.3, we must provide the conduits and panel capacity for future installation for the required number of spaces (2 in this case). However, it is only when the equipment is to be installed that we need to refer to CBC and CEC. Section 11B-228.3.1 also reiterates this. Therefore, we would show the location of the conduit stub outs adjacent to 2 current parking spaces and would show space on the electric panel for the future equipment – and that is all. At this time, we do not need to show the requirements for EV accessibility when equipment is installed per Chapter 11B. Is my interpretation correct?
RESPONSE: CBC Chapter 11B accessibility provisions for EVCS apply when a project consists of one or more electric vehicle charging spaces served by an electric vehicle charger or other charging...
-
§ 38.23(c)(5) Slope
If the height of the vehicle floor from which the ramp is deployed is 3 inches or less above a 6-inch curb, a maximum slope of 1:4 is permitted; if the height of the vehicle floor from which...
-
DRIVE-UP ELECTRIC VEHICLE CHARGING STATION
An electric vehicle charging station in which use is limited to 30 minutes maximum and is provided at a location where the electric vehicle approaches in the forward direction, stops in...
-
DRIVE-UP ELECTRIC VEHICLE CHARGING STATION
An electric vehicle charging station in which use is limited to 30 minutes maximum and is provided at a location where the electric vehicle approaches in the forward direction, stops in...
-
§ 38.77(c)
(c) At all doors on level-entry vehicles, and at each entrance accessible by lift, ramp, bridge plate or other suitable means, handrails, stanchions, passenger seats, vehicle driver seat...
-
11B-407.4.10.2 Surfaces
Support rails shall be smooth and any surface adjacent to them shall be free of sharp or abrasive elements....
-
11B-407.4.10.2 Surfaces
Support rails shall be smooth and any surface adjacent to them shall be free of sharp or abrasive elements....
-
11B-407.4.10.2 Surfaces
Support rails shall be smooth and any surface adjacent to them shall be free of sharp or abrasive elements....
-
§ 38.175(b)
(b) All other high-speed rail cars shall comply with the similar provisions of subpart F of this part....
-
§ 38.23(b)(7) Platform gaps
When the platform is at vehicle floor height with the inner barrier (if applicable) down or retracted, gaps between the forward lift platform edge and the vehicle floor shall not exceed...
-
ADA and the FTA: Improving Transit Access for People with Disabilities
Transit opens doors to jobs, education, social connections and other opportunities. Since the Americans with Disabilities Act passed in 1990, the transit industry has worked to make...
-
§ 37.89 Remanufacture of intercity and commuter rail cars and purchase or lease of remanufactured intercity and commuter rail cars
[See subsections ...]
