Platforms on semi-automatic lifts may have a hand hold not exceeding 11/2 inches (28 mm) by 41/2 inches (113 mm) located between the edge barriers....
Search Results "Grab Bar Location"
Filters
Commonly Searched Documents
-
§ 38.159(b)(7) Platform gaps
-
11B-809.1 General
When located within public housing facilities, residential dwelling units shall comply with Section 11B-809....
-
11B-809.1 General
When located within public housing facilities, residential dwelling units shall comply with Section 11B-809....
-
11B-705.1.1.3 Color and contrast
Replacement of less than 20 percent of existing detectable warnings at a single contiguous location shall be permitted to be in-kind at existing curb ramps, islands, or cut-through medians...
-
Pilot Rock BS Series Bike Stand
Specifications: MATERIALS: Stalls are fabricated from ½” dia. steel bar and pre-assembled. Stalls offer 2-1/4” inside width. ...
-
Panda TS.60 Thermally Broken Folding Door System
This is achieved by using a polyamide iso-bar, with glass fibers integrated to provide maximum strength....
-
BACKGROUND
For the March 2016 Primary Election, the Board used 50 temporary and permanent Early Voting polling place locations at remote locations....
-
Clear floor space
Please provide a plan indicating locations of clear floor space to the side and front of bench as called for in 903.2....
-
Symmetry Vertical Platform Lift VPC-EL
Features : Nonskid platform surface Obstruction safety panel under platform (when not installed within a runway enclosure) Alarm and emergency stop switch Grab...
-
9.b [§ 4.7.5]
Place the level in the same position and location as each of the arrows in the illustration to the left [below]....
-
F216.12 Amusement Rides
In addition, where accessible unload areas also serve as accessible load areas, signs indicating the location of the accessible load and unload areas shall be provided at entries to queues...
-
1.12 Future Construction Theaters
Those seating plans have been specifically approved by the United States as compliant with the wheelchair seating location requirements of both Standard 4.33.3 and §§ 221 and 802 of the...
-
11B-806.2.4 Toilet and bathing facilities
Toilet and bathing fixtures required to comply with Sections 11B-603 through 11B-610 shall be permitted to be located in more than one toilet or bathing area, provided that travel between...
-
11B-307.4 Vertical clearance
The leading edge of such guardrail or barrier shall be located 27 inches (686 mm) maximum above the finish floor or ground....
-
13 [§ 4.7.10]
13 [§ 4.7.10] A corner-type curb ramp is located at the center (or apex) of a corner and is often aligned to direct users into the middle of an intersection....
-
5.4.4.1 Transfer Support Distance from Transfer Surface Recommendation for Stretchers
5.4.4.1 Transfer Support Distance from Transfer Surface Recommendation for Stretchers The Committee recommends locating the transfer support along the long side of the of the transfer...
-
216.12 Amusement Rides
In addition, where accessible unload areas also serve as accessible load areas, signs indicating the location of the accessible load and unload areas shall be provided at entries to queues...
-
406.6 Diagonal Curb Ramps
Diagonal curb ramps with flared sides shall have a segment of curb 24 inches (610 mm) long minimum located on each side of the curb ramp and within the marked crossing....
-
704.10 Vertical exposure
) vertically above the roof of an adjoining building or adjacent structure that is within a horizontal fire separation distance of 15 feet (4572 mm) of the wall in which the opening is located...
-
G2
Cots used by people who are blind or who have low vision should be in an easily locatable area....
-
Signs
A, “ADA Standards for Accessible Design,” (Standards) § 4.1.3(16)(a): Raised and Braille letters or numbers (Standards § 4.30.4); Mounting location (§ 4.30.6); Color...
