We would point out that the ADA applies this requirement to all new vehicles....
Search Results "Remanufactured Vehicle"
Filters
Commonly Searched Documents
-
Section 37.85 Purchase or Lease of New Intercity and Commuter Rail Cars
-
Section 37.165 Lift and Securement Use
An entity's vehicle is not required to pick up a wheelchair user when the securement locations are full, just as the vehicle may pass by other passengers waiting at the stop if the bus is...
-
§ 38.159(c)(6) Attachment
When in use for boarding or alighting, the ramp shall be firmly attached to the vehicle so that it is not subject to displacement when loading or unloading a heavy power mobility aid and...
-
§ 38.35(a)
(a) Vehicles in excess of 22 feet in length, used in multiple-stop, fixed-route service, shall be equipped with a public address system permitting the driver, or recorded or digitized human...
-
11B-812.7 Access aisle
Two vehicle spaces shall be permitted to share a common access aisle....
-
II. Rulemaking History
The Americans with Disabilities Act (ADA) requires the Access Board to issue guidelines for transportation vehicles—including buses, OTRBs, and vans—to ensure that new, used and remanufactured...
-
Floor and Ground Surfaces: ADA Standard Section 503.4
Section 503.4 covers the current ADA Standards for the floor and ground surfaces at passenger loading zones.
-
1012.4 Surface
The surface of parking spaces and pull-up spaces shall be firm and stable.
-
SCOPING QUESTIONS:
[See subsections ...]
-
T303 Handrails, Stanchions, and Handholds
[See subsections ...]
-
T210 Wheelchair Spaces
[See subsections ...]
-
T214 Operable Parts
[See subsections ...]
-
T207 Handrails, Stanchions, and Handholds
[See subsections ...]
-
14. In § 38.93(d)(3)
§ 38.93 [Amended] 14. In § 38.93(d)(3), remove the period at the end of the paragraph and add the following words: “,ensuring compliance with section 37.42, where applicable.” in...
-
1012.5 Slope
The slope of the surface of parking spaces and pull-up spaces shall not be steeper than 1:48 in any direction. EXCEPTION: Where the surface is other than asphalt, concrete, or...
-
1012.4 Surface
The surface of parking spaces and pull-up spaces shall be firm and stable.
-
§ 38.23(b)(1) Design load
(1) Design load. The design load of the lift shall be at least 600 pounds. Working parts, such as cables, pulleys, and shafts, which can be expected to wear, and upon which the lift...
-
§ 38.29(d)
(d) Handrails and stanchions shall be sufficient to permit safe boarding, on-board circulation, seating and standing assistance, and alighting by persons with disabilities.
-
§ 38.27 Priority seating signs
[See subsections ...]
-
§ 38.159(b)(10) Platform movement
(10) Platform movement. No part of the platform shall move at a rate exceeding 6 inches/second (150 mm/sec) during lowering and lifting an occupant, and shall not exceed 12...
-
C. Visibility Through a Window
C. Visibility Through a Window. Care should be taken so that the lift does not obscure the vision of the person occupying the securement position.
-
§ 38.23(b)(12) Use by standees
(12) Use by standees. Lifts shall accommodate persons using walkers, crutches, canes or braces or who otherwise have difficulty using steps. The platform may be marked to indicate a...
-
§ 38.83(c)(1) Design load
(1) Design load. Ramps or bridge plates 30 inches or longer shall support a load of 600 pounds, placed at the centroid of the ramp or bridge plate distributed over an area of 26...
-
§ 38.83(c)(7) Stowage
(7) Stowage. A compartment, securement system, or other appropriate method shall be provided to ensure that stowed ramps or bridge plates, including portable ramps or bridges plates...