Ski areas located on public lands are governed by ADA because they are providing public accommodations and also are governed by Section 504 of the Rehabilitation Act and related regulations...
Search Results "Signage Location"
Filters
Commonly Searched Documents
-
Accessibility Guidebook for Ski Areas Operating on Public Lands
-
Overview of FSTAG Implementation Process
It also can be used as a field guide when locating or rerouting a trail....
-
4.35.4 Bench
Where installed in conjunction with showers, swimming pools, or other wet locations, water shall not accumulate upon the surface of the bench and the bench shall have a slip-resistant surface...
-
Room Dimensions
For single-user toilet rooms, key considerations include the configuration of water closets and lavatories, clear floor spaces required at fixtures, turning space, the location and swing...
-
Definitions
“Election Day Surveyors” or “EDSs” are County personnel (or contractors) who will review compliance at polling place locations where temporary measures are to be implemented on Election...
-
ALTERNATIVES TO BARRIER REMOVAL
§36.305(b)(1) Providing curb service or home delivery; §36.305(b)(2) Retrieving merchandise from inaccessible shelves or racks; §36.305(b)(3) Relocating activities to accessible locations...
-
9.5 LOCKER ROOMS
., intended for use by people in wheelchairs shall be located no higher than 48 in (1220 mm) above the finished floor....
-
Is front-in only or angled parking prohibited for accessible parking spaces?
However, where van spaces are angled, the Standards require the access aisle to be located on the passenger side which is the side where vehicle ramps and lifts are typically deployed....
-
§ 38.159(b)(7) Platform gaps
Platforms on semi-automatic lifts may have a hand hold not exceeding 11/2 inches (28 mm) by 41/2 inches (113 mm) located between the edge barriers....
-
11B-809.1 General
When located within public housing facilities, residential dwelling units shall comply with Section 11B-809....
-
11B-705.1.1.3 Color and contrast
Replacement of less than 20 percent of existing detectable warnings at a single contiguous location shall be permitted to be in-kind at existing curb ramps, islands, or cut-through medians...
-
11B-809.1 General
When located within public housing facilities, residential dwelling units shall comply with Section 11B-809....
-
Grab bar clearance
ADAS doesn't seem to make any allowance for this and I haven't yet found an official statement that will accept a unit like that in a location like that....
-
Clear floor space
Please provide a plan indicating locations of clear floor space to the side and front of bench as called for in 903.2....
-
BACKGROUND
For the March 2016 Primary Election, the Board used 50 temporary and permanent Early Voting polling place locations at remote locations....
-
9.b [§ 4.7.5]
Place the level in the same position and location as each of the arrows in the illustration to the left [below]....
-
1.12 Future Construction Theaters
Those seating plans have been specifically approved by the United States as compliant with the wheelchair seating location requirements of both Standard 4.33.3 and §§ 221 and 802 of the...
-
11B-806.2.4 Toilet and bathing facilities
Toilet and bathing fixtures required to comply with Sections 11B-603 through 11B-610 shall be permitted to be located in more than one toilet or bathing area, provided that travel between...
-
11B-307.4 Vertical clearance
The leading edge of such guardrail or barrier shall be located 27 inches (686 mm) maximum above the finish floor or ground....
-
13 [§ 4.7.10]
13 [§ 4.7.10] A corner-type curb ramp is located at the center (or apex) of a corner and is often aligned to direct users into the middle of an intersection....
-
5.4.4.1 Transfer Support Distance from Transfer Surface Recommendation for Stretchers
5.4.4.1 Transfer Support Distance from Transfer Surface Recommendation for Stretchers The Committee recommends locating the transfer support along the long side of the of the transfer...
-
406.6 Diagonal Curb Ramps
Diagonal curb ramps with flared sides shall have a segment of curb 24 inches (610 mm) long minimum located on each side of the curb ramp and within the marked crossing....