Knee clearance shall extend 25 inches (635 mm) maximum under an element at 9 inches (230 mm) above the finish floor or ground....
Search Results "Enhanced 9-1-1"
-
306.3.2 Maximum Depth
-
306.2.1 General
Space under an element between the finish floor or ground and 9 inches (230 mm) above the finish floor or ground shall be considered toe clearance and shall comply with 306.2....
-
306.2.1 General
Space under an element between the finish floor or ground and 9 inches (230 mm) above the finish floor or ground shall be considered toe clearance and shall comply with 306.2....
-
Section 35.151(b)(3) Alterations to historic facilities
Section 35.151(b)(3) Alterations to historic facilities The final rule renumbers the requirements for alterations to historic facilities enumerated in current Sec. 35.151(d)(1) and (2...
-
1016.5 Obstacles
Obstacles on outdoor recreation access routes, passing spaces, and resting intervals shall not exceed 1/2 inch (13 mm) in height measured vertically to the highest point....
-
M301.2.1 Adjustability (Section-by-Section Analysis)
As discussed in Section IV.B.1.a....
-
Sloped Entries
Sloped Entries Sloped entries must comply with ADAAG accessible route provisions (36 inch minimum width, maximum 1:12 or 8.33% slope), except that the surface does not need to be slip...
-
Obstructions [4.7.8]
Where space at the top is less than 48 inches, side flares must have a maximum slope of 1:12 instead of 1:10 at the curb face....
-
1016.5 Obstacles
Obstacles on outdoor recreation access routes, passing spaces, and resting intervals shall not exceed 1/2 inch (13 mm) in height measured vertically to the highest point....
-
1014.2.1 Transfer Access
The surface of the clear ground space is required to be firm and stable, and to slope not steeper than 1:48 in any direction....
-
Section 35.151(b)(3) Alterations to historic facilities (Section-by-Section Analysis)
) Alterations to historic facilities (Section-by-Section Analysis) The final rule renumbers the requirements for alterations to historic facilities enumerated in current § 35.151(d)(1)...
-
PUBLIC HOUSING
[DSA-AC & HCD 1-AC] Housing facilities owned, operated, or constructed by, for or on behalf of a public entity including but not limited to the following: 1....
-
11B-1009.2.1 Pool lift location
Exceptions: 1. Where the entire pool depth is less than 36 inches (914 mm) or greater than 48 inches (1219 mm), compliance with Section 11B-1009.2.1 shall not be required....
-
Technical Memorandum TM 2017-25 Door and Gate Surfaces
TM 2017-25 Door and Gate Surfaces Effective Date: April 1, 2017 2012 TAS Reference: 404.2.10 404.2.10 requires door and gate surfaces within 10 inches (255mm) of the finish...
-
Regulations about Ticket Sales
Does the transaction of selling a ticket fall under a public accommodation's requirement to communicate effectively with an individual with a disability, per 36.303(c)(1) ?...
-
I. BACKGROUND
Introduction 1. This Consent Decree is agreed to, by and between, Plaintiff United States of America and QuikTrip Corporation. 2. ...
-
B. JURISDICTION
. § 12182(b)(1)(B); 28 C.F.R. § 36.203. To do so, an entity must: a. ...
-
11B-202.4 Path of travel requirements in alterations, additions and structural repairs
Widening doors. 9. Installing offset hinges to widen doorways. 10. Eliminating a turnstile or providing an alternative accessible route. 11. ...
-
Sections 35.108(a)(2) and 36.105(a)(2) Definition of ‘‘disability’’—Rules of Construction
(i), the ‘‘record of’’ prong in paragraph (a)(1)(ii) or the ‘‘regarded as’’ prong in paragraph (a)(1)(iii)....
-
GUARD OR GUARDRAIL
GUARD [DSA-AC , HCD 1 & HCD 2] OR GUARDRAIL. ...
-
804.6.2 Operable Parts
EXCEPTIONS: 1. Appliance doors and door latching devices shall not be required to comply with 309.4. 2....
-
1008.2.6.1 Accessibility
Ground surfaces shall comply with ASTM F 1951 (incorporated by reference, see "Referenced Standards" in Chapter 1)....
-
§382.151(c)(2)
(2) Your reservation agents, contractors, and Web sites must provide information equivalent to that required by paragraph (c)(1) of this section to passengers with a disability using those...
-
408.1 General
Limited-use/limited-application elevators shall comply with 408 and with ASME A17.1 (incorporated by reference, see "Referenced Standards" in Chapter 1)....