Smaller, refined design makes an ideal application for many knowing act applications Beveled edges are less susceptible to damage by deflecting harsh impacts from any side...
Search Results "Latch Side Clearance"
Filters
Commonly Searched Documents
-
BEA Inc. PBS45 Series Door Access 4.5" Square Push Plate (Push to Open)
-
Landscape Forms Inc. FGP Trash Receptacle
Litter available in single units with the opening on the side The litter is freestanding or surface mount The standard black polyethylene base is prefilled with concrete and then plugged...
-
AJW Architectural Products UG30-A Series UG30-A12 12" Concealed Set Screw Flange, 1.5" Diameter Grab Bar - Configuration A
Strength: Bars with a 1 1/2" offset clearance will support loads in excess of 900lbs when properly installed....
-
AJW Architectural Products UG20-A Series UG20-A12 12" Concealed Set Screw Flange, 1.25" Diameter Grab Bar - Configuration A
Strength: Bars with a 1 1/2" offset clearance will support loads in excess of 900lbs when properly installed....
-
Activar Hiawatha HG111 & HG112 Straight Tubular Pulls and HG113 & HG114 Push Bars
Brass, Bronze, Stainless Steel Pull Diameter: 1-1/4" CTC: 12", 18", 27-3/4", 33" Overall: 13-3/4", 19-1/4", 29" Push Bar, 34-1/4" Push Bar Projection: 3", 3", 2-1/2", 2-1/2" Clearance...
-
Door King Inc. 1150 Overhead Gate and Door opener
Low profile ideal for low clearance underground parking areas Shock mounts greatly reduce noise and vibration from being transferred into above offices or apartments Direct drive limit...
-
2. Standing Supports
The Committee recommended that for single-ramped entry raised platforms with wheelchair spaces, the standing supports located on two sides of the platform have a minimum of 34 inches between...
-
Guest Bathrooms
Where a seat is provided in a standard roll-in shower compartment, it shall be a folding type, shall be installed on the side wall adjacent to the controls, and shall extend from the back...
-
Lutron Sivoia QED Kirbé Vertical Motorized Drapery System
An industry first, the Kirbé vertical drapery system smoothly pulls fabric up and completely out of the way - unlike traditional draperies that move from side-to-side....
-
11B-221.2.3.2 Vertical dispersion
Vertical, center, or side aisles adjoining bleacher seating that are stepped or tiered are not considered entry points. Advisory 11B-221.2.3.2 Vertical dispersion Exception 2. ...
-
Issue 5: Tactile arrow (in line)
If the needed adjustment is minor, it may be possible to shim behind one side of the device to align the arrow with the crosswalk....
-
1117B.1, Item 5
The bubbler shall be activated by a manually operated system complying with Section 1117B.6, Item 4 that is front mounted or side mounted and located within 6 inches (152mm) of the front...
-
1117B.1, Item 4
The bubbler shall be activated by a manually operated system complying with Section 1117B.6, Item 4 that is front mounted or side mounted and located within 6 inches (152mm) of the front...
-
1012.3 Opening limitations
Exceptions: The triangular openings formed by the riser, tread and bottom rail at the open side of a stairway shall be of a maximum size such that a sphere of 6 inches (152 mm)...
-
Wheelbase Definition
The larger of the dimensions measured on the right and left side of the mobility device were considered for the analysis....
-
2. Armrests Requirement
commenter that addressed whether armrests should be required was a manufacturer who requested that beds, cots, and stretchers be excluded from the requirements as they are required to have side...
-
F235.2 Boat Slips
For example, a single pier 25 feet (7620 mm) long and 5 feet (1525 mm) wide (the minimum width specified by 1003.3) allows boats to moor on three sides....
-
R305 Detectable Warning Surfaces (Section-by-Section Analysis)
At curb ramps and blended transitions, detectable warning surfaces must extend the full width of the ramp run (excluding flared sides), blended transition, or turning space....
-
235.2 Boat Slips
For example, a single pier 25 feet (7620 mm) long and 5 feet (1525 mm) wide (the minimum width specified by Section 1003.3) allows boats to moor on three sides....
-
Check-Out Aisles [7.3]
Operable controls, including card swipes, must be with maximum reach heights (54 inches for a side reach, 48 inches for a forward reach)....
-
Protruding Objects and Trails
Objects that extend into the travel way of a trail from the side or from overhead can be hazardous to people who are paying more attention to their companions than the travel route (figure...
-
R304.1 General
On large corner radiuses, it will be necessary to indent the gutter break on one side of the curb ramp in order for the curb ramp to meet the gutter break at right angles....
-
3.3.5 Seat Height
We computed the occupied seat height by measuring a point underneath an individual’s buttocks using an extension of the electromechanical probe that we slipped in from the side between the...
-
2.11 Perceived Color of Detectable Warnings
The complete set of color descriptions given by participants for each detectable warning and side walk combination is presented in Appendix F....
