FINISH: Standard finish: hot dip galvanized after fabrication for maximum protection from elements. ...
Search Results "Expected Maximum Flight Duration"
- Pilot Rock PQT3-4 Square Pedestal Table Using Aluminum
- Allegion Falcon MA Series Mechanical Locks
- AJW Architectural Products U1521EA Series Automatic 120 Volt Hand Dryer, Satin Finish - Surface Mounted
- Symmons Ultra-Sense Battery Powered Sensor Faucet S-6060
- Allegion Falcon 1490 Series Exit Devices
- BEST Door Lever Hardware Cylindrical Locks - 9K
- Midmark 630 HUMANFORM™ Procedures Table
- Panda UTS.60 Thermally Broken ULTRA Folding Door System
- Panda S.10 All Aluminum Lift & Slide System
-
General: ADA Standard Section 232.1
Section 232.1 of the ADA Standards covers information in the current ADA Standards on scoping requirements for detention facilities and correctional facilities.
-
NOTES
[and] to a position low enough [19 inches maximum] to allow for the comfort of providers who choose to work in a seated position, to enable patients to keep their feet on the floor while...
-
§ 382.70 Disability-related complaints received by carriers
Foreign air carriers are covered by this section only with respect to disability-related complaints associated with any flight segment originating or terminating in the United States....
- Children's Harbor
-
Section 36.211 Maintenance of Accessible Features (Preamble, Section-by-Section Analysis)
The Act requires that, to the maximum extent feasible, facilities must be accessible to, and usable by, individuals with disabilities....
-
Dispersion
In the final rule, the Board has revised the dispersion requirement to allow some overlap (10% maximum) between rooms and to ensure that at least one room provides both wheelchair access...
-
36 CFR Part 1195 Standards for Accessible Medical Diagnostic Equipment - Preamble
The MDE Standards will allow independent entry to, use of, and exit from the equipment by individuals with disabilities to the maximum extent possible....
-
5.8.1.2.1 Ramped Entry Slope Recommendations
The maximum slope for a ramp in the 2010 Standards is a rise of 1 vertical inch for each 12 inches of horizontal distance slope....
-
ADOPTION OF A 19 INCH HEIGHT MINIMIZES COSTS TO HEALTH CARE PROVIDERS
OF A 19 INCH HEIGHT MINIMIZES COSTS TO HEALTH CARE PROVIDERS In the absence of Committee consensus commending a departure from the existing broadly accepted transfer surface height maximum...
-
Introduction
104.1.1 and clarified in its advisory, they are intended to apply only to certain sections of the 2010 ADA Standards where dimensions are stated as single dimensions or as simple minimums or maximums...
-
§35.133 Maintenance of Accessible Features
The Act requires that, to the maximum extent feasible, facilities must be accessible to, and usable by, individuals with disabilities....
-
Conclusions
The maximum values recorded for thigh breadth and shoulder breadth serves as a reference value should accommodations for these users be necessary....
-
M301.2.3 Transfer Sides
Guidance from IEC 60601-2-52 does establish the maximum vertical obstruction of being not less than 1" below the top of the transfer surface....
-
Key Study findings:
Of the participants who attempted and were successful with performing two-step transfers, the 50th percentile could attain a 7 inch vertical height difference which is below the maximum...
-
Protocol A Heights Obtained
The upper 95th percentile transfer heights were 3" higher for the NDVWSC than the HERL group for the maximum height transfer....