(A) Are an integral part of the seating area and are dispersed to all accessible seating levels; and...
Search Results "Designated Aisle Seat (Assembly)"
Filters
Commonly Searched Documents
-
§ 36.308(a)(1)(ii)(A)
-
§382.83(c)
(c) If you do not provide advance seat assignments to passengers, you must allow passengers specified in §382.81 to board the aircraft before other passengers, including other “preboarded...
-
Notes
vertical distance between the seat and footplate)....
-
A5. Accessible Parking Spaces
Are all accessible parking spaces, including the access aisle, relatively level (1:50 or 2%) in all directions?...
-
Built-in Elements
BUILT-IN ELEMENTS Dining/work surfaces 11B-226, 11B-902.2 Benches 11B-903.2 Check out aisles...
-
Built-in Elements
BUILT-IN ELEMENTS Dining/work surfaces 11B-226, 11B-902.2 Benches 11B-903.2 Check out aisles...
-
Can accessible routes run behind other parking spaces?
The ADA Standards require that an accessible route connect parking space access aisles to the accessible entrance they serve but they do not specifically prohibit the accessible route from...
-
Use of the ISA Under the ADA
Standards require use of the ISA to label or provide direction to certain accessible spaces and elements, including parking spaces, entrances, toilet and bathing facilities, and check-out aisles...
-
Adjustable height protocol
Adjustable height protocol: From initial setup, only the height of the platform was adjusted incrementally: higher (Figure 3) and lower than the subject’s seat. ...
-
11B-1009.2 Pool lifts
There are a variety of seats available on pool lift. Pool lift seats with backs enable a larger population of persons with disabilities to use the lift....
-
11B-903.4 Back support
Back support shall be 48 inches (1219 mm) long minimum and shall extend from a point 2 inches (51 mm) maximum above the seat surface to a point 18 inches (457 mm) minimum above the seat...
-
11B-903.4 Back support
Back support shall be 48 inches (1219 mm) long minimum and shall extend from a point 2 inches (51 mm) maximum above the seat surface to a point 18 inches (457 mm) minimum above the seat...
-
§382.41(a)
(a) The specific location of seats, if any, with movable armrests (i.e., by row and seat number);...
-
S.R. Smith Splash! Pool Lift Video 3: Resolution
pool lift such as the control box, actuator, actuator cable, motor cable, motor assembly, and gear....
-
Inclusion Solutions Poll Star Voting Booth
The Poll Star Accessible Booth is extremely easy to assemble, and can be placed into service in just minutes....
-
Aqua Creek Revolution Pool Lift
The higher weight capacity, adjustable seat height, and wider seat gives access to so many additional users and the design is very reminiscent of other lift designs lending an air of familiarity...
-
Pilot Rock UT and UTH Series End Accessible Picnic Table Using Lumber
Model UT and UTH End Accessible Picnic Tables are designed for most public applications. Built rugged, but with less weight, easier to move. ...
-
4.4.1 General
Section 4.3.1 does not apply to built-in benches provided in assembly areas such as amphitheaters. These benches are covered by sections F221.2.1.1, F221.2.2, and 903 of the ABAAS....
-
Places of Public Accommodation and Commercial Facilities
categories listed in the statute, including stores and shops, restaurants and bars, sales or rental establishments, service establishments, theaters, places of lodging, recreation facilities, assembly...
-
Pilot Rock Bench B110C with Full-length Grab Bar
The Accessible Bench incorporates the ABA and ADA suggested design guidelines for accessible seating....
-
5.2 Q. If a building design contains a mix of single-story flats on grade and single-story flats located above grade over a public parking area, do the flats over the parking area have to be accessible?
Thus, the definition includes situations where the design plan is such that more than one floor of a building may be accessed by means of an accessible route (for an example, see Question...
-
11B-903.4 Back support
Back support shall be 48 inches (1219 mm) long minimum and shall extend from a point 2 inches (51 mm) maximum above the seat surface to a point 18 inches (457 mm) minimum above the seat...
-
11B-224.8.2 More than 50-bed facilities
Facilities with more than 50 beds that provide common use bathing facilities, shall provide at least one roll-in shower with a seat that complies with Section 11B-608....
-
11B-604.6 Flush controls
If plumbing valves are located directly behind the toilet seat, flush valves and related plumbing can cause injury or imbalance when a person leans back against them....
