5.8.1.2.3 Double Ramped Entry – Edge Protection on the Platform Sides. A minimum 2 inch high edge protection must be provided on both sides of the platform for double ramped entry...
Search Results "Clear Floor Space"
Commonly Searched Documents
-
5.8.1.2.3 Double Ramped Entry – Edge Protection on the Platform Sides
-
5.8.1.2.2 Single Ramped Entry – Edge Protection on the Platform and Platform Sides
5.8.1.2.2 Single Ramped Entry – Edge Protection on the Platform and Platform Sides. A 2 inch high edge protection must be provided on the back of the platform, opposite the entry...
-
5.8.1.2.4 Edge Protection on Platforms 1½ inches or less in Height Recommendations
5.8.1.2.4 Edge Protection on Platforms 1½ inches or less in Height Recommendations The Committee recommends that no edge protection be required on platforms of 1½ inches or less...
-
5.8.1.2.3 Double Ramped Entry - Edge Protection on the Platform sides Recommendations
5.8.1.2.3 Double Ramped Entry - Edge Protection on the Platform sides Recommendations The Committee recommends a minimum two-inch high edge protection on both sides of the...
-
What accessibility requirements apply to EV charger installation outside of California?
RESPONSE: To the extent that EVCS are a public accommodation or commercial facility they are covered by the federal law of the Americans with Disabilities Act. Specific technical...
-
§ 36.302(f)(7) Secondary ticket market
(7) Secondary ticket market.
-
12162(a)(3)(A)(ii)(I)
(I) to park and secure wheelchairs (to accommodate individuals who wish to remain in their wheelchairs) equal to not less than the total number of single-level rail passenger coaches...
-
12162(a)(3)(A)(ii)(II)
(II) to fold and store wheelchairs (to accommodate individuals who wish to transfer to coach seats) equal to not less than the total number of single-level rail passenger coaches in...
-
M303.3.3.2 Cross Slope
The cross slope of ramp runs shall not be steeper than 1:48.
-
M303.3.3 Ramped
Changes in level greater than ½ inch (13 mm) high shall be ramped and shall comply with M303.3.3.
-
M303.3.3.4 Edge Protection
Ramps with drop offs ½ inch (13 mm) or greater shall provide edge protection 2 inches (50 mm) high minimum on each side.
-
Common Questions (Passenger Loading Zones)
Common Questions
-
11B-1010.1 Turning space
A circular turning space 60 inches (1524 mm) diameter minimum with slopes not steeper than 1:48 shall be provided at shooting facilities with firing positions....
-
Section 36.302(f) Ticketing (Section-by-Section Analysis)
The result was that it was not entirely clear that some of the provisions that were not repeated also were intended to apply to season tickets....
-
11B-809.10.2 Number of complying bathing rooms and fixtures
One bathing room and one fixture of each type within the dwelling unit shall be designed to comply with the following: Maneuvering space in toilet, bathing and shower rooms shall...
-
7. Clear Width
(Note: wheelchairs need 36" of clear passage width) [28 CFR 36.304(b)(4)] Yes __ No __ N/A __ Comments: ___________________________________________...
-
b. Exception for Base Support Allowance and Unobstructed Knee and Toe Space
The MDE Advisory Committee recommended allowing obstructions into the knee and toe clear space, up to a height and depth that still permits the footrests of wheelchairs to pass over it....
-
DSA IR 11B-7 REQUIREMENTS FOR ACCESSIBLE PARKING SPACES (with revisions issued through Jan. 2011)
This fine posting requirement is in addition to other signage regulations contained in the California Building Code for accessible parking spaces. 2....
-
M305.3.1 Length
Horizontal standing support gripping surfaces shall comply with M305.3.1.1, horizontal standing support gripping surfaces on diagnostic equipment containing a wheelchair space shall comply...
-
1132A.4 Level floor or landing
The floor or landing on each side of a door shall be level....
-
Section 35.151(g) Assembly areas (Section-by-Section Analysis)
As the Department explained in the NPRM, however, this provision was not designed to prohibit temporary seating that increases seating for events (e.g., placing temporary seating on the floor...
-
Sec.36.308(b) New construction and alterations
The provision and location of wheelchair seating spaces in newly constructed or altered assembly areas shall be governed by the standards for new construction and alterations in subpart...
-
Floor Naming and Numbering
This is a little abstract one, but if you look at those elevator buttons, whether you’re in a building in San Francisco and you come in on the east side of the building and it’s Floor Level...
- Willoughby Industries ASETW1490FM Ligature-Resistant Floor Mounted Blowout Series Water Closet