The 1991 Standards at section 4.2.6 establish a maximum side-reach height of 54 inches. The 2010 Standards at section 308.3.1 reduce that maximum height to 48 inches....
Search Results "Applicable Standard"
Commonly Searched Documents
-
Side reach (Section-by-Section Analysis)
-
Executive Summary
Our findings are compared to those in three other countries and to the current standards in all four countries. Many differences exist in both the standards and research studies....
-
12. Annual Commitment for Program Access Improvements
Each subsequent fiscal year throughout the Compliance Period will commence on July 1 of the applicable year. 12.4....
- Nondiscrimination in Health Programs and Activities
- United Nations Disability Statistics
-
11B-1009.2.6 Footrests and armrests
[2010 ADA Standards] 1009.2.6 Footrests and Armrests. Footrests shall be provided and shall move with the seat....
-
11B-806.2.3.1 Personal lift device floor space
ETA Editor's Note The clearance prescribed for a personal lift device at CBC 11B-806.2.3.1 is not required by 2010 ADA Standards....
-
11B-406.5.8 Counter slope
[2010 ADA Standards] 406.2 Counter Slope. Counter slopes of adjoining gutters and road surfaces immediately adjacent to the curb ramp shall not be steeper than 1:20....
-
11B-405.9.2 Curb or barrier
ETA Editor's Note CBC requires either a curb or a barrier for edge protection at ramps, and does not recognize the extended floor or ground surface also permitted by 2010 ADA Standards...
-
11B-605.4 Flush controls
[2010 ADA Standards] 605.4 Flush Controls. Flush controls shall be hand operated or automatic. Hand operated flush controls shall comply with 309....
-
11B-206.4.8 Service entrances
[2010 ADA Standards] 206.4.8 Service Entrances. If a service entrance is the only entrance to a building or to a tenancy in a facility, that entrance shall comply with 404....
-
The Americans with Disabilities Act of 1990
While the ADA has five separate titles, Title II is the section specifically applicable to “public entities” (state and local governments) and the programs, services, and activities they...
-
Examples of Contractor Cases
An applicant who was deaf in one ear was rejected for an aircraft mechanic job because the company feared that his impairment might cause a future workers' compensation claim....
-
Technical Memorandum TM 2017-25 Door and Gate Surfaces
This standard is applicable to doors and gates on an accessible route. Doors which meet conditions described in this Technical Memorandum will be in compliance with TAS 404.2.10....
- VGo Telepresence Robot
-
General: ADA Standard Section 223.1
Section 223.1 of the ADA Standards covers information in the current ADA Standards on scoping requirements for medical care and long-term care facilities.
-
ACCESSIBLE SPACE
Space that complies with these standards....
-
Companion Seats
Section 4.33.3 of the 1991 Standards required at least one fixed companion seat to be provided next to each wheelchair space....
-
216 and 703 Signs
216 and 703 Signs The following types of signs, though they are not specifically subject to the 1991 Standards requirement for signs, will now be explicitly exempted by sections 216 and...
-
Power-Operated Doors or Gates
Comments noted that since the ASME/ANSI A18.1 standard requires such doors and gates to be self-closing, the specification in the rule was redundant. Response....
-
H29
[ADA Standards § 4.25.3] Yes No Note: For many emergency shelters, evacuees are not expected to use shower or bathing facilities due to the short period they may stay at the...
-
410.5 Digital Encoding of Speech (Section-by-Section Analysis)
This section proposes to require ICT with two-way voice communication to transmit and receive digitally encoded speech in the manner specified by ITU-T Recommendation G.722, a consensus standard...
-
Question 16
Should the Department develop a general standard that specifies requirements for beds wherever accessible sleeping accommodations are required?...
-
A4.30.4 RAISED OR INDENTED CHARACTERS OR SYMBOLS
Braille characters can be used in addition to standard alphabet characters and numbers....