height - 54.25" Writing surface height - 33.75" Writing surface depth - 18" Writing surface width at front - 21" Clearance under writing surface (knee space) - 31" Storage case dimensions...
Search Results "Minimum Dimension"
Commonly Searched Documents
- Inclusion Solutions Poll Star Voting Booth
-
Guest Rooms
Table 224.4 Guest Rooms with Communication Features Total Number of Guest Rooms Provided Minimum Number of Required Guest Rooms with Communication Features...
- Sloan WETS 2050.1001-1.28 Manual HET Flushometer and HET Wall Hung Water Closet
- Caroma® USA Sydney Smart 305 Easy Height Elongated 1 Piece Toilet
- Caroma® USA Caravelle Smart 270 One Piece Toilet
- GE® 30" Slide-In Electric Convection Range JS750EFES
- Allegion Von Duprin 33A/35A Series Exit Devices
-
Swinging Doors and Gates: ADA Standard Section 404.2.4.1
Section 404.2.4.1 covers the current ADA Standards for maneuvering clearances at swinging doors and gates.
-
Door and Gate Surfaces: ADA Standard Section 404.2.10
Section 404.2.10 covers the current ADA Standards for door and gate surfaces on manual doors and gates.
-
11B-233.3.1.2.6.1 Single building with one common (lobby) entrance
Sites where either Test No. 1 or Test No. 3 is used and it is determined that an accessible route to the common (lobby) entrance is not required, a minimum of 20 percent of the ground floor...
-
11B-809.12 Electrical receptacles, controls and switches
controls and switches shall be located as follows: Where there is no obstruction, 48 inches (1219 mm) maximum measured from the top of the receptacle box and 15 inches (381 mm) minimum...
-
11B-404.2.10 Door and gate surfaces
Tempered glass doors without stiles and having a bottom rail or shoe with the top leading edge tapered at 60 degrees minimum from the horizontal shall not be required to meet the 10 inch...
-
Section 36.406 Standards for New Construction and Alterations (Preamble, Section-by-Section Analysis)
which require the Attorney General to promulgate standards for accessible design for buildings and facilities subject to the Act and this part that are consistent with the supplemental minimum...
-
11B-235.2 Boat slips
TABLE 11B-235.2 BOAT SLIPS TOTAL NUMBER OF BOAT SLIPS PROVIDED IN FACILITY MINIMUM NUMBER OF REQUIRED ACCESSIBLE BOAT SLIPS...
-
810.5.3 Platform and Vehicle Floor Coordination
Low-level platforms shall be 8 inches (205 mm) minimum above top of rail....
-
235.2 Boat Slips
Table 235.2 Boat Slips Total Number of Boat Slips Provided in Facility Minimum Number of Required Accessible Boat Slips 1 to 25...
-
Location and Spacing
Recommendations: In general, it is recommended that lamp intensity and spacing be maximized to allow the minimum number of fixtures within a room or space....
-
Scoping [4.1.2(5)]
Lot Total Minimum Accessible Lot Total Minimum Accessible stand. van total stand....
-
219 Assistive Listening Systems
The minimum number of receivers to be provided shall be equal to 4 percent of the total number of seats, but in no case less than two....
-
Design Speed
The AASHTO Guide for the Development of Bicycle Facilities (p. 36) specifies 30 km/h (20 mi/h) as the minimum design speed that should be used on shared use paths (figure 47).(2) It goes...
-
68.70. Registered Accessibility Specialists--Qualifications for Certification
TexReg 884) (a) An applicant seeking departmental certification as a registered accessibility specialist in order to perform plan review or inspection services shall meet the following minimum...
-
Appendix A to Part 37—Standards for Accessible Transportation Facilities
require the Access Board to adopt accessibility guidelines; sections 204(c) and 306(c) of the ADA require the Department of Transportation to adopt regulatory standards “consistent with the minimum...