Handrails may project into the required clear width of the ramp at each side 3½ inches (89 mm) maximum at the handrail height....
Search Results "Latch Side Clearance"
Commonly Searched Documents
-
11B-405.5 Clear width
-
Tips for Assisting People Who Are Deaf, Hard of Hearing, or Deaf-Blind
Make sure the words you print are “right side up” for the person receiving the message. Write as large as possible and start in the upper left for a “W” and finish in the upper right....
- Inpro Corporation JointMaster® AR Series Seal Expansion Joint Systems
- Inpro Corporation Clickeze® ADA Shower Curtain
- Behavioral Safety Products #FV600 Ligature Resistant Flush Valve Cover
- Delta Proximity Gooseneck HW-BB Recessed Box Trim Set SS 620TP3321TR-BB-SS
- Delta Single Hole Faucet with Proximity™ Sensing Technology Hardwired 590-PLGHDFHW
- Delta Proximity Gooseneck HW-BB Recessed Box Trim Set SS 620TP3321TR-SS
- TownSteel ED5500 Grade 1 Panic Rim Device
- TownSteel CSRC Series, Grade 2, Clutched, Conical Rose Cylindrical Locks
- TownSteel CB Series, Grade 2 Non-Clutched Flat Rose Cylindrical Locks
- BEA Inc. Indoor & Outdoor Door Entry Keypads
- Norton Surface Mounted Heavy Duty 9500 Series Door Closer
- Allegion Falcon RU/RW Series Mechanical Locks
- Allegion Schlage AL-Series Mechanical Locks
-
Vehicle Parking
Sometimes, a single parking area for a double camping unit accommodates two vehicles side-by-side....
-
ETA Public Telephone Summary Chart and Survey Instructions
If, in an exterior location, and dial tone first service is available, then a side reach telephone may be installed instead of the required forward reach telephone. [4.1.3(17)(a)3] g....
-
Section 35.151(g)(2)
This rule, which is designed to prevent a public entity from placing wheelchair spaces and companion seats on one side of the facility only, is consistent with the Department’s enforcement...
-
Escalators
The ASME code requires steps to be demarcated by yellow lines 2 inches wide maximum along the back and sides of steps (ASME A17.1, section 6.1.3.5.6)....
-
404.2.10 Door and Gate Surfaces
Swinging door and gate surfaces within 10 inches (255 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
-
505.6 Gripping Surface
Handrail gripping surfaces shall be continuous along their length and shall not be obstructed along their tops or sides....
-
5.8.1 Wheelchair Spaces on Raised Platforms Recommendations
Where wheelchair spaces can be entered only from the side, the wheelchair space shall be 60 inches deep minimum....
-
Utility and Sewage Hookups [1011.2, 1011.3, and 1011.6]
Internet connections, in camping units with mobility features and at sewage hookups in dump stations, a minimum of 30 by 60 inches of clear ground space must be provided with the long side...
-
711.3.2 Membrane penetrations
Outlet boxes on opposite sides of the wall shall be separated as follows: 1.1. By a horizontal distance of not less than 24 inches (610 mm); 1.2....