A 32 inch (815 mm) clear opening will not provide sufficient width when entered through a turn into an amusement ride....
Search Results "Seat Width"
Commonly Searched Documents
-
1002.4.4.2 Side Entry
-
1132A.9 Smooth surface
Swinging door or gate surfaces within 10 inches (254 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
-
Edge Protection
Recommendation: At narrow routes in particular, consider maintenance of adjacent surfaces as raised or flush or wider route widths in consideration of minimum maneuvering and passage requirements...
-
Rough Form and Foundation Inspection
slope). 11B-403 Verify forms for sidewalks, ramps, landings, curb ramps and clear floor spaces are correctly installed so proper slopes, cross slopes, widths...
-
Floor Plan of Elevator Cars [4.10.9]
In alterations, smaller car sizes (minimum 47 inch width and 69 inch length) are permitted in cases of technical infeasibility, including where limited by existing shaft configurations (...
-
Shape and Diameter
A gripping surface width between 1¼ to 1½ inches diameter is specified....
-
Rough Form and Foundation Inspection
slope). 11B-403 Verify forms for sidewalks, ramps, landings, curb ramps and clear floor spaces are correctly installed so proper slopes, cross slopes, widths...
-
4.34.6.7* OVENS
For side-opening ovens, the door latch side shall be next to the open counter space, and there shall be a pull-out shelf under the oven extending the full width of the oven and pulling out...
-
1.1.12 Ramp cross slope
slope of ramps by establishing elevations at the extreme edges of the ramp at the top and bottom of the ramp and calculate the cross slope at these two locations using the horizontal ramp width...
-
11B-1002.4.4.2 Side entry
A 32 inch (815 mm) clear opening will not provide sufficient width when entered through a turn into an amusement ride....
-
11B-1002.4.4.2 Side entry
A 32 inch (815 mm) clear opening will not provide sufficient width when entered through a turn into an amusement ride....
-
11B-704.2.1.2 Forward approach
If an additional 6 inches (152 mm) in width of clear floor space is provided, creating a clear floor space of 36 inches by 48 inches (914 mm by 1219 mm), the enclosure may extend more than...
-
Serving Counters
A minimum width of 36 inches should be provided with a 42 inch width preferred, if readily achievable....
-
5.2.1.4 Transfer Surface Size Recommendations for Imaging Equipment (M301)
All X-ray tables meet the 28-inch table width....
-
A) Accessible Parking
If the accessible route is located in front of the space, install wheelstops or other barriers to keep vehicles from reducing width below 36 inches....
-
Service Animal Issues
If no single seat in the cabin will accommodate the animal and passenger without causing an obstruction, you may offer the option of purchasing a second seat, traveling on a later flight...
- Landscape Forms Inc. Towne Square Bench Collection
- HEWI System 800 Adjustable Mirror
- Autoadapt Turny Evo
- Landscape Forms Inc. Petoskey Bench Collection
-
Section 36.303(g)(1) Audio Description Device
the NPRM, at proposed § 36.303(g)(1)(iii), the Department used the term “individual audio description listening device” to refer to the “individual device that patrons may use at their seats...
-
11B-226.2 Dispersion
Dining surfaces required to comply with Section 11B-902 shall be dispersed throughout the space or facility containing dining surfaces for each type of seating in a functional area....
-
Temporary Facilities
Temporary Facilities ADAAG also requires temporary facilities such as bleachers for tournaments, assembly seating areas, portable toilet facilities, concessions, and all other available...
-
Specific areas of dispute. (Section-by-Section Analysis)
Commenters expressed specific concern with the application of a safe harbor to four discrete areas: reach ranges, ATMs, seating in assembly areas, and access to swimming pools. ...