In standard roll-in type shower compartments, the controls, faucets, and the shower spray unit shall be located on the back wall of the compartment adjacent to the seat 16 inches...
Search Results "Element"
Commonly Searched Documents
-
11B-608.5.2 Standard roll-in type shower compartments
-
11B-202 Existing buildings and facilities
SECTION 11B-202 Existing buildings and facilities 11B-202.4 Path of travel requirements in alterations, additions and structural repairs. Exceptions: 7. Projects...
-
4.3.2(2)
(2) At least one accessible route shall connect accessible buildings, facilities, elements, and spaces that are on the same site....
-
Section 36.403 Alterations: Path of Travel (Section-by-Section Analysis)
required to retrofit such elements to reflect incremental changes in the 2010 Standards solely because of an alteration to a primary function area served by that path of travel....
-
4.1.1(2)
(2) At least one accessible route complying with 4.3 shall connect accessible buildings, facilities, elements, and spaces that are on the same site....
-
4.1.2(2)
(2) At least one accessible route complying with 4.3 shall connect accessible buildings, accessible facilities, accessible elements, and accessible spaces that are on the same site....
- Whitehall Mfg. Plumbing Solutions for the Modern Healthcare Environment
- Geberit Monolith Installation
-
11B-201.1 Scope, 11B-201.2 Application based on building or facility use, 11B-202.2 Additions, 11B-202.3 Alterations
Alteration of single elements shall comply with the applicable requirements of Division 2 for that element....
-
203.1 General
Sites, buildings, facilities, and elements are exempt from these requirements to the extent specified by 203....
-
Alternate Roll-In Type Shower Compartments: ADA Standard Section 608.5.3
Section 608.5.3 covers the current ADA Standards for controls in alternate roll-in type shower compartments.
-
11B-608.5.3 Alternate roll-in type shower compartments
In alternate roll-in type shower compartments, the controls, faucets, and shower spray unit shall be located on the side wall of the compartment adjacent to the 16 inches (406 mm)...
-
11B-604.3.2 Overlap
The required clearance around the water closet shall be permitted to overlap the water closet, associated grab bars, dispensers, sanitary napkin disposal units, coat hooks, shelves,...
-
Parallel Approach to Kitchen Sinks
Comment. Commenters recommended that a parallel approach should be allowed at kitchen sinks in spaces without a cook top or conventional range, consistent with the ANSI A117.1...
-
608.3.1 Transfer Type Shower Compartments
In transfer type compartments, grab bars shall be provided across the control wall and back wall to a point 18 inches (455 mm) from the control wall. Figure 608.3.1 Grab Bars...
-
608.3.1 Transfer Type Shower Compartments
In transfer type compartments, grab bars shall be provided across the control wall and back wall to a point 18 inches (455 mm) from the control wall.
-
Equipment and furniture.
Question seven of the ANPRM asked for comment on whether regulatory guidance is needed with respect to the acquisition and use of mobile, portable, and other free-standing equipment...
-
2. Roll-in Shower Size
2. If there are more than 50 guestrooms/suites, are all required roll-in showers at least 30" wide by 60" long or 36" wide by 60", as configured in Figure 57 below, so persons who...
-
608.3.1 Transfer Type Shower Compartments
608.3.1 Transfer Type Shower Compartments. In transfer type compartments, grab bars shall be provided across the control wall and back wall to a point 18 inches (455 mm) from the...
-
Q. Other Showers in Accessible Guestrooms/Suites
Q. Other Showers in Accessible Guestrooms/Suites - Accessible guestrooms/suites that are not required to have roll-in showers may have an accessible bathtub, a small shower as shown...
-
12162(e)(2)(B)(ii) Alterations to a primary function area
(ii) Alterations to a primary function area It shall be considered discrimination, for purposes of section 12132 of this title and section 794 of title 29, with respect to...
-
Sinks [4.24]
Sinks [4.24] ADAAG provides technical specifications for both "lavatories" and "sinks." Requirements for lavatories in ADAAG 4.19 apply to fixtures for hand washing in toilet or...
-
4.24.3 Knee Clearance
Knee clearance that is at least 27 in (685 mm) high, 30 in (760 mm) wide, and 19 in (485 mm) deep shall be provided underneath sinks.