Changes in level up to 1/4 in (6 mm) may be vertical and without edge treatment (see Fig. 7(c)). Changes in level between 1/4 in and 1/2 in (6 mm and 13 mm) shall be beveled with a...
Search Results "Bus Rapid Transit"
-
4.5.2 Changes in Level
-
4.5.2 CHANGES IN LEVEL
Changes in level up to 1/4 in (6 mm) may be vertical and without edge treatment (see Fig. 7(c)). Changes in level between 1/4 in and 1/2 in (6 mm and 13 mm) shall be beveled with a...
-
11B-303.2 Vertical
Changes in level of ¼ inch (6.4 mm) high maximum shall be permitted to be vertical and without edge treatment. [2010 ADAS] 303.2 Vertical. Changes in level of ¼ inch high...
-
11B-303.2 Vertical
Changes in level of ¼ inch (6.4 mm) high maximum shall be permitted to be vertical and without edge treatment. [2010 ADA Standards] 303.2 Vertical. Changes in level of ¼ inch high...
-
303.2 Vertical
Changes in level of 1/4 inch (6.4 mm) high maximum shall be permitted to be vertical.
-
303.2 Vertical
303.2 Vertical. Changes in level of ¼ inch (6.4 mm) high maximum shall be permitted to be vertical. Figure 303.2 Vertical Change in Level
-
11B-209 Passenger drop-off and loading zones and bus stops.
[See subsections ...]
-
Section 37.93 One Car Per Train Rule
Section 37.93 One Car Per Train Rule This section implements the statutory directive that all rail operators (light, rapid, commuter and intercity) have at least one car per train accessible...
-
R304.5.1 Width
The clear width of curb ramp runs (excluding any flared sides), blended transitions, and turning spaces shall be 1.2 m (4.0 ft) minimum....
-
T207.2 Passenger Doorways
Handrails or stanchions shall be provided at passenger doorways in a configuration that permits grasping and use from outside the non-rail vehicle and throughout the boarding and...
-
T204.3 Doorways with Level Boarding and Alighting
Doorways with level boarding and alighting shall comply with T502.3.
-
§ 38.57(c)
(c) The diameter or width of the gripping surface of handrails and stanchions shall be 11/4 inches to 11/2 inches or provide an equivalent gripping surface and shall provide a...
-
II-5.3000 Curb ramps
This schedule must be included as part of a transition plan (see II−8.3000)....
-
T202.1 General
Non-rail vehicles shall provide at least one means of accessible boarding and alighting that serves each designated stop on the fixed route to which the vehicle is assigned. Non-rail...
-
Transition Plans
The regulation required transition plans to be completed by December 31, 1997....
-
11B-218.2 New and altered fixed guideway stations
New and altered stations in rapid rail, light rail, commuter rail, intercity rail, high speed rail, and other fixed guideway systems shall comply with Sections 11B-810.5 through 11B-810.10...
-
10.2.1(1)
(1) Where new bus stop pads are constructed at bus stops, bays or other areas where a lift or ramp is to be deployed, they shall have a firm, stable surface; a minimum clear length of 96...
-
T204.1 General
Doorways on non-rail vehicles shall comply with T204.
-
T210.4 Location
Wheelchair spaces shall be located as near as practicable to doorways that provide a means of accessible boarding and alighting.
-
T204 Doorways
[See subsections ...]
-
T203.1 General
Steps on non-rail vehicles shall comply with T405.
-
CHAPTER 2: SCOPING REQUIREMENTS
[See subsections ...]
-
T215.2.3 Doorways
Doorways that provide a means of accessible boarding and alighting shall be identified on the exterior of the non-rail vehicle by the International Symbol of Accessibility complying...
-
12185(a) Purposes
(a) Purposes The Office of Technology Assessment shall undertake a study to determine